Infiniti G37 Coupe. Manual — part 1060
PREPARATION
RF-65
< PREPARATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000001693852
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tool
INFOID:0000000001693853
Tool number
(Kent-Moore No.)
Tool name
Description
(J39570)
Chassis ear
Locating the noise
(J43980)
NISSAN Squeak and Rattle
Kit
Repairing the cause of noise
SIIA0993E
SIIA0994E
Tool name
Description
Engine ear
Locating the noise
SIIA0995E
RF-66
< ON-VEHICLE REPAIR >
SUNROOF UNIT ASSEMBLY
ON-VEHICLE REPAIR
SUNROOF UNIT ASSEMBLY
Exploded View
INFOID:0000000001693856
REMOVAL
1.
Drain hose
2.
Side trim
3.
TORX bolt
4.
Glass lid
5.
TORX bolt
6.
Sunroof motor assembly
7.
Front sunroof bracket (LH/RH)
8.
Rear sunroof bracket (LH/RH)
9.
Sunroof unit assembly
10. Drain connector
JMKIA1266ZZ
SUNROOF UNIT ASSEMBLY
RF-67
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
DISASSEMBLY
Removal and Installation
INFOID:0000000001693857
REMOVAL
CAUTION:
• Always work with a helper.
• Fully close the glass lid assembly, before removal, then do not operate sunroof motor assembly after
removal.
1.
Sunshade stopper
2.
Rear drain assembly
3.
Sunshade
4.
Wind deflector
5.
Sunroof frame
JMKIA1267ZZ
RF-68
< ON-VEHICLE REPAIR >
SUNROOF UNIT ASSEMBLY
• When taking sunroof unit out, use cloths to protect the seats and trim from damage.
• After installing the sunroof unit and glass lid, perform the leak test and check that there is no mal-
function.
1.
Remove the headlining. Refer to
INT-24, "SUNROOF : Removal and Installation"
2.
Disconnect drain hoses.
3.
Remove the glass lid. Refer to
RF-70, "Removal and Installation"
4.
Remove sunroof motor assembly. Refer to
RF-73, "Removal and Installation"
.
5.
Remove assistance grip bracket.
6.
Remove sunroof bracket bolts and nuts.
7.
Remove nuts from the front end and side rail, and then remove sunroof unit assembly from roof panel.
8.
Remove sunroof unit assembly through the passenger compartment while being careful not to damage
the seats and trim.
INSTALLATION
1.
Bring sunroof unit assembly into passenger compartment.
2.
Temporarily tighten the mounting nuts to the side rail of sunroof unit assembly.
3.
Temporarily tighten the mounting nuts to the front end of sunroof unit assembly.
4.
Tighten the installation points diagonally excluding the installation point of the sunroof bracket around the
roof opening.
5.
Tighten the sunroof bracket bolts of the vehicle side, and then tighten the bolt of the rail side.
6.
Tighten the mounting nuts to the front end and side rail.
7.
Install the assistance grip bracket.
8.
Install the sunroof motor assembly. Refer to
RF-73, "Removal and Installation"
9.
Install the glass lid. Refer to
RF-70, "Removal and Installation"
.
10. Install the side trim.
11. Connect drain hoses.
12. Install the headlining. Refer to
INT-24, "SUNROOF : Removal and Installation"
.
Disassembly and Assembly
INFOID:0000000001693858
DISASSEMBLY
1.
Remove sunshade stopper mounting from the rear end of sunroof frame.
2.
Remove rear drain assembly from sunroof frame.
3.
Remove sunshade from the rear end of sunroof frame.
4.
Remove wind deflector from sunroof frame.
ASSEMBLY
Assemble in the reverse order of disassembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст