Infiniti G37 Coupe. Manual — part 705
EXT-34
< ON-VEHICLE REPAIR >
FRONT PILLAR FINISHER
3.
Remove body side weather-strip retainer (1) mounting screws
(A) and clip (B), and then remove body side weather-strip
retainer (1).
4.
Remove front pillar finisher (1) fixing clips with remover tool (A).
5.
Remove front pillar finisher.
Installation
Install in the reverse order of removal.
NOTE:
If body side weather-strip is reused, remove double-faced adhesive tape from molding and body sides, clean
the applied area, and then install the parts shown in the figure into the body after applying new double-faced
adhesive tape to it.
CAUTION:
• Do not let air between contact surfaces when installing.
• To secure contact, do not wash vehicle within 24 hours after installation.
JMKIA1248ZZ
: Clip
JMKIA1249ZZ
DOOR OUTSIDE MOLDING
EXT-35
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
DOOR OUTSIDE MOLDING
Exploded View
INFOID:0000000001677494
Refer to
for symbols in the figure.
Removal and Installation
INFOID:0000000001677495
REMOVAL
1.
Remove door finisher. Refer to
INT-11, "Removal and Installation"
2.
Remove door mirror assembly. Refer to
MIR-50, "DOOR MIRROR ASSEMBLY : Removal and Installa-
3.
Twists and pull up to upper side, and then remove front door out-
side molding (1).
INSTALLATION
Install in the reverse order of removal.
1.
Door outside molding
2.
Door panel assembly
JMKIA1250ZZ
JMKIA0116GB
EXT-36
< ON-VEHICLE REPAIR >
DOOR PARTING SEAL
DOOR PARTING SEAL
Exploded View
INFOID:0000000001677496
Removal and Installation
INFOID:0000000001677497
REMOVAL
1.
Fully open door.
2.
Remove door parting seal mounting plastic clips with remover tool.
3.
Remove door parting seal.
INSTALLATION
Install in the reverse order of removal.
1.
Door parting seal
2.
Door panel assembly
: Clip
JMKIA1251ZZ
TRUNK LID FINISHER
EXT-37
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
TRUNK LID FINISHER
TRUNK LID OUTER FINISHER
TRUNK LID OUTER FINISHER : Exploded View
INFOID:0000000001677498
Refer to
for symbols in the figure.
TRUNK LID OUTER FINISHER : Removal and Installation
INFOID:0000000001677499
REMOVAL
1.
Fully open trunk lid.
2.
Remove trunk lid finisher inner. Refer to
INT-29, "Removal and Installation"
1.
Trunk lid finisher outer
2.
Trunk lid panel assembly
3.
Rivet
4.
Trunk drip cover RH
5.
Trunk drip cover LH
6.
Double-faced adhesive tape
[t: 4.0 mm (0.157 in)]
7.
Double-faced adhesive tape
[t: 2.5 mm (0.098 in)]
: Clip
: Metal clip
JMKIA1252ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст