Infiniti F50. Manual — part 107
DISASSEMBLY
AT-313
D
E
F
G
H
I
J
K
L
M
A
B
AT
27. Disconnect fluid temperature sensor 2 connector.
CAUTION:
Be careful not to damage connector.
28. Remove terminal cord assembly connectors from bracket.
CAUTION:
Be careful not to damage connector.
29. Disconnect revolution sensor connector.
CAUTION:
Be careful not to damage connector.
30. Straighten terminal clips to free terminal cord assembly and rev-
olution sensor harness then remove terminal clips.
CAUTION:
Hang down terminal cord assembly and revolution sensor
harness toward outside so as not to disturb removal of con-
trol valve assembly.
31. Remove bolts A, B and C from control valve assembly.
SCIA2581E
SCIA2584E
SCIA2313E
SCIA2314E
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA2312E
AT-314
DISASSEMBLY
32. Remove control valve assembly from transmission case.
CAUTION:
When removing, be careful with the manual valve notch and
manual plate height.Remove it vertically.
33. Remove fluid temperature sensor 2 with bracket from control
valve assembly.
34. Remove bracket from fluid temperature sensor 2.
35. Remove tightening bolts for output shaft & companion flange
complement and transmission case.
SCIA2315E
SCIA2582E
SCIA2583E
SCIA2316E
DISASSEMBLY
AT-315
D
E
F
G
H
I
J
K
L
M
A
B
AT
36. Tap output shaft & companion flange complement with soft ham-
mer.
37. Remove output shaft & companion flange complement from
transmission case. (With needle bearing)
38. Remove intermediate shaft from transmission case by rotating
left/right.
39. Remove needle bearing from transmission case.
SCIA2317E
SCIA2318E
SCIA2319E
SCIA2440E
AT-316
DISASSEMBLY
40. Remove revolution sensor from transmission case.
CAUTION:
Be careful not to damage harness with the edge of case.
41. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using another
screwdriver.
42. Remove reverse brake retaining plate, drive plate, driven plate
and dish plate from transmission case.
CAUTION:
Be careful to remove it with N-spring.
43. Remove snap ring (fixing spring retainer) using a flat-bladed
screwdriver.
SCIA2320E
SCIA2321E
SCIA2322E
SCIA2323E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст