Infiniti F50. Manual — part 648
TURN SIGNAL AND HAZARD WARNING LAMPS
LT-59
C
D
E
F
G
H
I
J
L
M
A
B
LT
Ground is supplied to terminals 2 of each front turn signal lamp through body grounds E42 and E62.
Ground is supplied to terminals 6 of each rear turn signal lamp through body grounds B17and B57.
Ground is supplied to terminals 5 of each door mirror through body grounds M24 and M114.
Ground is supplied to combination meter terminal 62 through body grounds M24 and M114.
With power and ground supplied, the combination flasher unit controls the flashing of the hazard warning
lamps.
MULTI-REMOTE CONTROL SYSTEM OPERATION
Power is supplied at all times
●
through 15A fuse [No. 22, located in the fuse block (J/B) NO.1]
●
to combination flasher unit terminal 4.
Ground is supplied to combination flasher unit terminal 6, when the multi-remote control system is triggered
through the BCM.
Refer to
BL-52, "REMOTE KEYLESS ENTRY SYSTEM"
in “BODY, LOCK & SECURITY SYSTEM (BL)” sec-
tion.
The BCM is energized.
Power is supplied through terminal 8 of the combination flasher unit
●
to front turn signal lamp LH terminal 1
●
to rear turn signal lamp LH terminal 5
●
to door mirror (driver side) terminal 7
●
to combination meter terminal 45.
Power is supplied through terminal 3 of the combination flasher unit
●
to front turn signal lamp RH terminal 1
●
to rear turn signal lamp RH terminal 5
●
to door mirror (passenger side) terminal 7
●
to combination meter terminal 46.
Ground is supplied to terminals 2 of each front turn signal lamp through body grounds E42 and E62.
Ground is supplied to terminals 6 of each rear turn signal lamp through body grounds B17and B57.
Ground is supplied to terminals 5 of each door mirror through body grounds M24 and M114.
Ground is supplied to combination meter terminal 62 through body grounds M24 and M114.
With power and ground supplied, the BCM controls the flashing of the hazard warning lamps.
LOW TIRE PRESSURE WARNING CONTROL SYSTEM
When ID is normally registered to each transmitter in the LOW TIRE PRESSURE WARNING CONTROL
UNIT, the hazard warning lamp flashes twice. Refer to
WT-13, "ID Registration Procedure"
WHEELS & TIRES (WT)” section.
LT-60
TURN SIGNAL AND HAZARD WARNING LAMPS
Schematic
EKS000VD
TKWM0029E
TURN SIGNAL AND HAZARD WARNING LAMPS
LT-61
C
D
E
F
G
H
I
J
L
M
A
B
LT
Wiring Diagram — TURN —
EKS000T9
TKWM0406E
LT-62
TURN SIGNAL AND HAZARD WARNING LAMPS
TKWM0407E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст