Infiniti QX56 (Z62). Manual — part 841
INT-12
< SYMPTOM DIAGNOSIS >
SQUEAK AND RATTLE TROUBLE DIAGNOSES
PIIB8742E
FRONT DOOR FINISHER
INT-13
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
REMOVAL AND INSTALLATION
FRONT DOOR FINISHER
Exploded View
INFOID:0000000006220241
1.
Front door panel
2.
Front inside door seal
3.
Front door finisher
4.
Bumper rubber
5.
Door finisher cap
6.
Inside handle escutcheon
7.
Front door grip cap
8.
Step lamp
9.
Power window switch finisher
10. Power window switch
11. Door mirror corner cover
12. BSW/BSI indicator
13. Seat memory switch
14. Front door inside handle
: Clip
: Pawl
: Metal clip
JMJIA4235ZZ
INT-14
< REMOVAL AND INSTALLATION >
FRONT DOOR FINISHER
Removal and Installation
INFOID:0000000006220242
CAUTION:
• When removing, always use a remover tool that is made of plastic.
• Never damage the body.
REMOVAL
1.
Fully open door window.
2.
Remove door finisher cap (1) using a small flat-bladed screw-
driver (A) as shown by the arrow in the figure, and then remove
front door finisher mounting bolt.
CAUTION:
Use a small flat-bladed screwdriver wrapped in tape (B).
3.
Insert a remover tool (A) between front door grip cap (1) and
front door grip to disengage front door grip cap fixing pawls as
shown by the arrow in the figure, and then remove fixing screws
4.
Remove step lamp, and then disconnect step lamp harness connector. Refer to
5.
Remove bumper rubber.
6.
Insert a remover tool (A) between door finisher and door panel
to disengage fixing clips and metal clip as shown by the arrow in
the figure.
CAUTION:
Insert a remover tool into the part shown in the figure
(between the clips and the door panel).
7.
Disconnect BSW/BSI indicator harness connector.
8.
Disconnect seat memory switch harness connector.
9.
Disconnect mood lamp harness connector.
10. Disconnect power window switch harness connector and clamp.
11. Disconnect lock knob cable and inside handle cable from front door inside handle.
12. Remove front door finisher from front door panel.
13. Remove the following parts after removing front door finisher.
• Mood lamp.
• Door mirror corner cover.
• Power window switch.Refer to
PWC-74, "Removal and Installation"
.
• BSW/BSI indicator. Refer to
DAS-525, "Removal and Installation"
.
: Pawl
JMJIA4013ZZ
: Pawl
JMJIA4014ZZ
: Clip
: Metal clip
JMJIA4015ZZ
FRONT DOOR FINISHER
INT-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
• Seat memory switch. Refer to
ADP-137, "Removal and Installation"
.
• Front door inside handle. Refer to
DLK-241, "INSIDE HANDLE : Removal and Installation"
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Visually check the clips, pawls and metal clip for deformation and damage during installation.
Replace with new ones if necessary.
• When installing front door finisher, check that clips, pawls and metal clip are securely fitted in body
panel holes, and press them in.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст