Infiniti EX35. Manual — part 1458
TM-220
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
v.
Remove bearing race from output shaft.
vi. Remove output shaft from transmission case by rotating left/
right.
vii. Remove parking gear (1) from output shaft (2).
viii. Remove seal rings (1) from output shaft.
44. Remove needle bearing from transmission case.
SCIA5245E
SCIA5030E
JPDIA0029ZZ
JPDIA0030ZZ
SCIA5031E
TRANSMISSION ASSEMBLY
TM-221
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
45. Remove revolution sensor from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings, etc. to get on the sensor's front
edge magnetic area.
• Do not place in an area affected by magnetism.
46. Remove reverse brake snap ring (fixing plate) using 2 flat-
bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
47. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
48. Remove N-spring from transmission case.
49. Remove reverse brake drive plates, driven plates, dish plates
and retaining plate transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
50. Remove snap ring (fixing spring retainer) using a flat-bladed
screwdriver.
SCIA2320E
SCIA5032E
SCIA5214E
SCIA2322E
SCIA2323E
TM-222
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
51. Remove spring retainer and return spring from transmission
case.
52. Remove seal rings from drum support.
53. Remove needle bearing from drum support edge surface.
54. Remove reverse brake piston from transmission case with com-
pressed air. Refer to
CAUTION:
Care should be taken not to abruptly blow air. It makes pis-
tons incline, as the result, it becomes hard to disassemble
the pistons.
SCIA2324E
SCIA3333E
SCIA2796E
SCIA5047E
TRANSMISSION ASSEMBLY
TM-223
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
55. Remove D-rings from reverse brake piston.
56. Use a pin punch [4 mm (0.16 in) dia. commercial service tool] to
knock out retaining pin.
57. Remove manual shaft retaining pin with pair of nippers.
58. Remove manual plate (with parking rod) from manual shaft.
59. Remove parking rod from manual plate.
SCIA6330E
SCIA2328E
SCIA2329E
SCIA5715E
SCIA5220E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст