Infiniti G35 (V35) Sedan. Manual — part 1410
TM-332
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
80. Install torque converter while aligning notches of torque con-
verter with notches of oil pump.
CAUTION:
Install torque converter while rotating it.
81. Measure distance (A) to make sure that torque converter is in
proper position.
Inspection
INFOID:0000000000957191
INSPECTION AFTER REMOVAL
• Check foreign materials in oil pan to help determine causes of mal-
function. If the ATF is very dark, smells burned, or contains foreign
particles, the frictional material (clutches, band) may need replace-
ment. A tacky film that will not wipe clean indicates varnish build
up. Varnish can cause valves, servo, and clutches to stick and can
inhibit pump pressure.
- If frictional material is detected, perform A/T fluid cooler
cleaning. Refer to
.
SCIA5010E
B
: Scale
C
: Straightedge
Distance (A)
: Refer to
.
JPDIA0042ZZ
SCIA5199E
TRANSMISSION ASSEMBLY
TM-333
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
• Check torque converter one-way clutch using a check tool as
shown at figure.
1.
Insert a check tool into the groove of bearing support built into
one-way clutch outer race.
2.
When fixing bearing support with a check tool, rotate one-way
clutch spline using a screwdriver.
3.
Make sure that inner race rotates clockwise only. If not, replace
torque converter assembly.
SCIA3171E
TM-334
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
OIL PUMP
OIL PUMP
Exploded View
INFOID:0000000000957192
Disassembly
INFOID:0000000000957193
1.
Remove oil pump housing from oil pump cover.
2.
Remove oil pump housing oil seal using a flat-bladed screw-
driver.
CAUTION:
Be careful not to scratch oil pump housing.
1.
O-ring
2.
Oil pump cover
3.
O-ring
4.
Oil pump housing
5.
Oil pump housing oil seal
SCIA5227E
SCIA5228E
SCIA2840E
OIL PUMP
TM-335
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
3.
Remove O-ring from oil pump housing.
4.
Remove O-ring from oil pump cover.
Assembly
INFOID:0000000000957194
1.
Install O-ring to oil pump cover.
2.
Install O-ring to oil pump housing.
SCIA2841E
SCIA5230E
SCIA5230E
SCIA2841E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст