Infiniti G35 (V35) Sedan. Manual — part 710
FL-12
< ON-VEHICLE REPAIR >
FUEL TANK
1.
Turn ignition switch “ON” (with engine stopped), and check connections for leakage by applying fuel pres-
sure to fuel piping.
2.
Start engine and rev it up and make sure there are no fuel leaks at the fuel system tube and hose connec-
tions.
• After removing/installing rear suspension assembly, make sure to adjust wheel alignment and then, adjust
neutral position of steering angle sensor. Refer to
RSU-6, "Wheel Alignment Inspection"
"4WAS FRONT ACTUATOR NEUTRAL POSITION ADJUSTMENT : Description"
.
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
FL-13
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
DISASSEMBLY AND ASSEMBLY
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
Exploded View
INFOID:0000000000956374
Disassembly
INFOID:0000000000956375
CAUTION:
Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.
Remove fuel level sensor unit as follows:
1.
Disconnect harness connector (A).
• Hold connector by fingers and pull it out, because there is no
stopper release tab.
2.
Using suitable tool, pull up tabs points as shown in the figure
(two points) to release the lock.
CAUTION:
Be careful not to damage it.
1.
Fuel level sensor unit
2.
Fuel filter and fuel pump assembly
PBIC1081E
JPBIA0141ZZ
1
: Fuel level sensor unit
A
: Pull up tabs
JPBIA0142ZZ
FL-14
< DISASSEMBLY AND ASSEMBLY >
FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
3.
After fixing tabs are disengaged, slide fuel level sensor unit (1)
out in direction shown by the arrow.
CAUTION:
Do not disassemble fuel filter and fuel pump assembly.
Assembly
INFOID:0000000000956376
CAUTION:
Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.
1.
Check for damage of fuel level sensor unit installation position on the side of fuel filter and fuel pump
assembly.
2.
Slide fuel level sensor unit until it aligns to installation groove, then insert it until it stops.
• After inserting, apply force in reverse direction (removal direction) to ensure it cannot be pulled out.
3.
Connect the black (A) and white (B) harnesses so that they are
in the positions shown in the figure.
• Securely insert harness connector until it stops.
A
: Pull
JPBIA0143ZZ
PBIC3387E
SERVICE DATA AND SPECIFICATIONS (SDS)
FL-15
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Fuel Tank
INFOID:0000000000956377
Standard and Limit
Fuel tank capacity
Approx. 76 (20 US gal, 16-5/8 Imp gal)
Fuel recommendation
Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст