Infiniti G35 (V35) Sedan. Manual — part 1404
TM-308
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
65. Remove return spring from servo assembly.
66. Remove O-rings from servo assembly.
67. Remove needle bearing (1) from rear extension (2WD) or
adapter case (AWD).
68. Remove parking actuator support from rear extension (2WD) or
adapter case (AWD).
69. Remove parking pawl (with return spring) and pawl shaft from
rear extension (2WD) or adapter case (AWD).
SCIA5717E
SCIA5719E
SCIA6179J
SCIA3423E
SCIA3424E
TRANSMISSION ASSEMBLY
TM-309
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
70. Remove return spring (1) from parking pawl (2).
71. Remove rear oil seal from rear extension (2WD) or adapter case
(AWD).
CAUTION:
Be careful not to scratch rear extension (2WD) or adapter
case (AWD).
Assembly
INFOID:0000000000957190
1.
As shown in the figure, use a drift [22 mm (0.87 in) dia. commer-
cial service tool] to drive manual shaft oil seals into the transmis-
sion case until it is flush.
CAUTION:
• Do not reuse manual shaft oil seals.
• Apply ATF to manual shaft oil seals.
SCIA6180J
SCIA5481E
SCIA5259E
TM-310
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
2.
Install detent spring and spacer in transmission case. Tighten
detent spring and spacer bolt to the specified torque.
3.
Install manual shaft to transmission case.
4.
Install parking rod to manual plate.
5.
Install manual plate (with parking rod) to manual shaft.
6.
Install retaining pin into the manual plate and manual shaft.
a.
Fit pinhole of the manual plate to pinhole of the manual shaft
with a pin punch.
b.
Use a hammer to tap the retaining pin into the manual plate.
CAUTION:
Drive retaining pin to 2
±
0.5 mm (0.08
±
0.020 in) over the
manual plate.
SCIA5248E
SCIA5716E
SCIA5220E
SCIA5715E
SCIA5297E
TRANSMISSION ASSEMBLY
TM-311
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
7.
Install retaining pin into the transmission case and manual shaft.
a.
Fit pinhole of the transmission case to pinhole of the manual
shaft with a pin punch.
b.
Use a hammer to tap the retaining pin into the transmission
case.
CAUTION:
Drive retaining pin to 5
±
1 mm (0.20
±
0.04 in) over the trans-
mission case.
8.
Install O-rings to servo assembly.
9.
Install return spring to servo assembly.
10. Install servo assembly in transmission case.
11. Using a pair of snap ring pliers, install snap ring to transmission
case.
SCIA2427E
SCIA5719E
SCIA5717E
SCIA5679E
SCIA2333E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст