Infiniti G35 (V35) Sedan. Manual — part 1405
TM-312
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
12. Install D-rings in reverse brake piston.
13. Install reverse brake piston in transmission case.
14. Install needle bearing to drum support edge surface.
CAUTION:
Take care with the direction of needle bearing. Refer to
289, "Location of Adjusting Shims, Needle Bearings, Thrust
Washers and Snap Rings"
.
15. Install seal rings to drum support.
16. Install spring retainer and return spring in transmission case.
SCIA6330E
SCIA2325E
SCIA2796E
SCIA3333E
SCIA2324E
TRANSMISSION ASSEMBLY
TM-313
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
17. Set the SST on spring retainer and install snap ring (fixing spring
retainer) in transmission case while compressing return spring.
CAUTION:
Securely assemble them using a flat-bladed screwdriver so
that snap ring tension is slightly weak.
18. Install reverse brake drive plates, driven plates, dish plates and
retaining plate in transmission case.
CAUTION:
Take care with order of plates.
SCIA5877E
1
: Snap ring
2
: Retaining plate
3
: Drive plate
4
: Driven plate
5
: Dish plate
Drive plate /
Driven plate
: 6/6
SCIA6949E
TM-314
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
TRANSMISSION ASSEMBLY
19. Assemble N-spring.
20. Install reverse brake retaining plate in transmission case.
21. Install snap ring in transmission case.
22. Measure clearance between retaining plate and snap ring. If not
within specified clearance, select proper retaining plate.
23. Install needle bearing to transmission case.
CAUTION:
Take care with the direction of needle bearing. Refer to
289, "Location of Adjusting Shims, Needle Bearings, Thrust
Washers and Snap Rings"
.
SCIA5249E
SCIA2439E
Specified clearance “A”
Retaining plate: Refer to
SCIA3129E
SCIA5031E
TRANSMISSION ASSEMBLY
TM-315
< DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
24. Install revolution sensor to transmission case. Tighten revolution
sensor bolt to the specified torque.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings, etc. to get on the sensor's front
edge magnetic area.
• Do not place in an area affected by magnetism.
25. As shown in the figure, use the drift to drive rear oil seal into the
rear extension (2WD) or adapter case (AWD) until it is flush.
CAUTION:
• Do not reuse rear oil seal.
• Apply ATF to rear oil seal.
26. Install return spring (1) to parking pawl (2).
27. Install parking pawl (with return spring) and pawl shaft to rear
extension (2WD) or adapter case (AWD).
SCIA2320E
SCIA5477E
SCIA6180J
SCIA3424E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст