Infiniti I30 (A33). Manual — part 538
10. If the liquid tank also needs to be replaced, add an additional
5 m
(0.2 US fl oz, 0.2 Imp fl oz) of lubricant at this time.
Do not add this 5 m
(0.2 US fl oz, 0.2 Imp fl oz) of lubricant
if only replacing the compressor.
RHA065DD
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
SC
EL
IDX
SERVICE PROCEDURE
Maintenance of Lubricant Quantity in Compressor (Cont’d)
HA-111
Compressor
REMOVAL AND INSTALLATION
NHHA0230
RHA463E
Compressor Clutch
OVERHAUL
NHHA0231
RHA122F
SERVICE PROCEDURE
Compressor
HA-112
RHA136EB
REMOVAL
NHHA0232
I
When removing center bolt, hold clutch disc with clutch disc
wrench.
RHA399F
RHA124F
I
Remove the clutch disc using the clutch disc puller.
Insert the holder’s three pins into the holes in the clutch disc.
Rotate the holder clockwise to hook it onto the plate. Then,
tighten the center bolt to remove the clutch disc.
After removing the clutch disc, remove the shims from either
the drive shaft or the clutch disc.
RHA138E
I
Remove the snap ring using external snap ring pliers.
RHA139E
I
Pulley removal
Position the center pulley puller on the end of the drive shaft,
and remove the pulley assembly using any commercially avail-
able pulley puller.
To prevent the pulley groove from being deformed, the
puller claws should be positioned onto the edge of the
pulley assembly.
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
SC
EL
IDX
SERVICE PROCEDURE
Compressor Clutch (Cont’d)
HA-113
RHA125F
I
Remove the field coil harness clip using a pair of pliers.
RHA145E
I
Remove the snap ring using external snap ring pliers.
RHA126F
INSPECTION
NHHA0233
Clutch Disc
NHHA0233S01
If the contact surface shows signs of damage due to excessive
heat, replace clutch disc and pulley.
Pulley
NHHA0233S02
Check the appearance of the pulley assembly. If the contact sur-
face of pulley shows signs of excessive grooving, replace clutch
disc and pulley. The contact surfaces of the pulley assembly should
be cleaned with a suitable solvent before reinstallation.
Coil
NHHA0233S03
Check coil for loose connection or cracked insulation.
RHA142E
INSTALLATION
NHHA0234
I
Install the field coil.
Be sure to align the coil’s pin with the hole in the com-
pressor’s front head.
I
Install the field coil harness clip using a screwdriver.
SERVICE PROCEDURE
Compressor Clutch (Cont’d)
HA-114
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст