Infiniti QX56 (JA60). Manual — part 600
BLOWER MOTOR CONTROL SYSTEM
HAC-57
< COMPONENT DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
1. Disconnect A/C auto amp. connector.
2. Check continuity between A/C auto amp. harness connector
M50 (A) terminal 47 and rear air control (rear) harness connec-
tor R209 (B) terminal 5.
Is the inspection results normal?
YES
>> Replace A/C auto amp. Refer to
NO
>> Repair harness or connector.
Rear Blower Motor Component Inspection
INFOID:0000000005147708
COMPONENT INSPECTION
Rear Blower Motor Relay
Check circuit continuity between terminals by supplying 12 volts and
ground to coil side terminals of relays.
Rear Blower Motor
Check that there are no foreign particles inside the intake unit.
Apply 12 volts to terminal 2 and ground to terminal 1 and ensure that
the blower motor rotates freely and quietly.
Continuity should exist.
AWIIA0187ZZ
WJIA0973E
AWIIA1086ZZ
HAC-58
< COMPONENT DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
REAR AIR CONTROL SYSTEM
REAR AIR CONTROL SYSTEM
Rear Air Control System Description
INFOID:0000000005147709
SYSTEM DESCRIPTION
Component Parts
Rear air control system components are:
• A/C auto amp.
• Rear air control (front)
• Rear air control (rear)
• Air mix door motor (rear)
• Mode door motor (rear)
System Operation
Rear Air Control
When the REAR CTRL indicator is off the rear air control (front) will control all rear blower motor speeds and
the rear temperature and mode operations. When the REAR CTRL switch is pressed (indicator on), the rear
air control (rear) will control all the rear blower motor speeds and the rear temperature and mode operations.
Rear Air Control Component Function Check
INFOID:0000000005147710
SYMPTOM:
• Temperature cannot be adjusted from the rear air controls.
• Mode cannot be adjusted from the rear air controls.
INSPECTION FLOW
1.
CHECK FOR SERVICE BULLETINS
Check for any service bulletins.
>> GO TO 2.
2.
CONFIRM SYMPTOM BY PERFORMING REAR AIR CONTROL (FRONT) AIR MIX DOOR MOTOR OP-
ERATIONAL CHECK
AWIIA0197GB
REAR AIR CONTROL SYSTEM
HAC-59
< COMPONENT DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
1. Start and run engine to operating temperature.
2. Turn the rear blower motor to maximum speed from the rear air control (front).
3. Turn rear air control (front) temperature control dial clockwise and then counterclockwise (REAR CTRL
indicator off).
4. Check for hot air at rear discharge air outlets in the maximum heat position and cold air at discharge air
outlets in the maximum cold position.
Does the rear air control (front) operate properly?
YES
>> GO TO 3.
NO
>> Check rear air control (front). Refer to
HAC-59, "Air Mix Door Motor (Rear) Diagnosis Procedure"
.
3.
CONFIRM SYMPTOM BY PERFORMING REAR AIR CONTROL (REAR) AIR MIX DOOR MOTOR OPER-
ATIONAL CHECK
1. Press the REAR CTRL switch on rear air control (front) to send control to the rear air control (rear).
2. Turn rear air control (rear) temperature control dial slowly clockwise and then counterclockwise (REAR
CTRL indicator on).
3. Check for hot air at rear discharge air outlets in the maximum heat position and cold air at rear discharge
air outlets in the maximum cold position.
Does the rear air control (rear) operate properly?
YES
>> GO TO 4.
NO
>> Check rear air control (rear). Refer to
HAC-56, "Rear Air Control (Rear) Diagnosis Procedure #2"
.
4.
CONFIRM SYMPTOM BY PERFORMING REAR AIR CONTROL (FRONT) MODE OPERATIONAL CHECK
1. Press the REAR CTRL switch on rear air control (front) (REAR CTRL indicator off).
2. Press each mode switch and check for proper air discharge at the appropriate locations.
Does the rear air control (front) operate properly?
YES
>> GO TO 5.
NO
>> Check mode door motor (rear). Refer to
HAC-63, "Mode Door Motor (Rear) Diagnosis Proce-
.
5.
CONFIRM SYMPTOM BY PERFORMING REAR AIR CONTROL (REAR) MODE OPERATIONAL CHECK
1. Press the REAR CTRL switch on rear air control (front) to send control to the rear air control (rear).
2. Press each mode switch and check for proper air discharge at the appropriate locations.
Does the rear air control (rear) operate properly?
YES
>> System OK.
NO
>> Replace rear air control (rear). Refer to
VTL-7, "Removal and Installation"
.
Air Mix Door Motor (Rear) Diagnosis Procedure
INFOID:0000000005147711
Regarding Wiring Diagram information, refer to
SYMPTOM:
• Temperature control (rear) operation is malfunctioning.
DIAGNOSTIC PROCEDURE FOR INOPERATIVE AIR MIX DOOR MOTOR (REAR)
1.
CHECK REAR AIR CONTROL (FRONT) POWER SUPPLY
1. Disconnect rear air control (front) harness connector.
2. Turn ignition switch ON.
3. Check voltage between rear air control (front) harness connec-
tor R108 terminal 1 and ground.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair harness or connector.
Battery voltage should exist.
AWIIA0182ZZ
HAC-60
< COMPONENT DIAGNOSIS >
[AUTOMATIC AIR CONDITIONER]
REAR AIR CONTROL SYSTEM
2.
CHECK REAR AIR CONTROL (FRONT) LIN BUS VOLTAGE
Check voltage between rear air control (front) harness connector
R108 terminal 5 and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> GO TO 4.
3.
CHECK REAR AIR CONTROL (FRONT) GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between rear air control (front) harness con-
nector R108 terminal 6 and ground.
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Repair harness or connector.
4.
CHECK LIN BUS VOLTAGE CIRCUIT FOR OPEN
1. Turn ignition switch OFF.
2. Disconnect the mode door motor (rear) harness connector.
3. Check continuity between rear air control (front) harness con-
nector R108 (B) terminal 5 and A/C auto amp. harness connec-
tor M50 (A) terminal 48.
Is the inspection result normal?
YES
>> Replace A/C auto amp. Refer to
NO
>> Repair or replace harness as necessary.
5.
CHECK A/C AUTO AMP. FOR POWER AND GROUND FOR AIR MIX DOOR MOTOR (REAR)
1. Reconnect all disconnected parts.
2. Turn ignition switch ON.
3. Rotate temperature control dial (rear) to maximum heat.
4. Check voltage between A/C auto amp. harness connector M50
terminal 49 and terminal 50 while rotating temperature control
dial (front) to maximum cold.
Is the inspection result normal?
YES
>> GO TO 9.
NO
>> GO TO 6.
6.
CHECK AIR MIX DOOR MOTOR (REAR) CIRCUITS FOR OPEN
Battery voltage should exist.
AWIIA0183ZZ
Continuity should exist.
AWIIA0184ZZ
48 - 5
: Continuity should exist.
AWIIA0185ZZ
Connector
Terminals
Condition
Voltage
(Approx.)
(+) (-)
A/C auto amp.:
M50
49 50
Rotate temp
control dial
Battery
voltage
AWIIA0135ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст