Infiniti G35 (V35). Manual — part 193
DOOR
BL-159
C
D
E
F
G
H
J
K
L
M
A
B
BL
DOOR
PFP:80100
Fitting Adjustment
NIS000C8
DOOR
Longitudinal Clearance and Surface Height Adjustment at Front End
Loosen the hinge mounting bolts. Raise the front door at rear end to adjust.
STRIKER ADJUSTMENT
Adjust the striker so that it becomes parallel with the lock insertion
direction.
1.
Front fender
2.
Door outer
3.
Rear fender
PIIA3547E
LIIA0113E
BL-160
DOOR
Removal and Installation
NIS000C9
REMOVAL
CAUTION:
●
When removing and installing the door assembly, support the door with a jack and cloth to protect
the door and body.
●
When removing and installing door assembly, be sure to carry out the fitting adjustment.
●
Check the hinge rotating part for poor lubrication. If necessary, apply “body grease”.
●
After installing, check operation.
●
Operate with two workers, because of its heavy weight.
1.
Remove the door finisher. Refer to
EI-29, "Removal and Installation"
.
2.
Remove the door window and module assembly. Refer to
GW-52, "Removal and Installation"
.
3.
Pull the lever and remove the door harness connector while
removing tabs of door harness connector.
4.
Remove the mounting bolts of the check link on the vehicle.
5.
Remove the door-side hinge mounting nuts, then remove the
door assembly.
INSTALLATION
Install in the reverse order of removal.
PIIA2514E
SIIA0339E
PIIA0600E
DOOR
BL-161
C
D
E
F
G
H
J
K
L
M
A
B
BL
Door Weatherstrip
NIS000CA
REMOVAL
Remove the weatherstrip clips and remove weatherstrip.
INSTALLATION
Install in the reverse order of removal.
PIIA3560E
BL-162
DOOR LOCK
DOOR LOCK
PFP:80502
Component Structure
NIS000CB
Removal and Installation
NIS000CC
REMOVAL
1.
Remove the front door finisher. Refer to
EI-29, "Removal and Installation"
.
2.
Remove the front door window and front door module assembly. Refer to
.
3.
Disconnect the inside handle cable and lock knob cable from the
back side of the front door finisher.
4.
Remove door side grommet, and remove door key cylinder assembly (driver side) or outside handle
escutcheon (passenger side) bolts (TORX T30) from grommet hole.
1.
Front gasket
2.
Outside handle
3.
Door key cylinder (Driver side)
Outside handle escutcheon (pas-
senger side)
4.
Rear gasket
5.
Outside handle bracket
6.
grommet
7.
Key cylinder rod (Driver side only)
8.
Outside handle cable
9.
Door lock assembly
10. Inside handle knob cable
11.
Lock knob cable
12. Inside handle
PIIA4137E
PIIA0632E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст