Infiniti G35 (V35). Manual — part 194
DOOR LOCK
BL-163
C
D
E
F
G
H
J
K
L
M
A
B
BL
CAUTION:
Do not forcibly remove the TORX bolts (T30).
5.
Reach to separate the key cylinder rod connection (on the handle). If no door key cylinder is found, GO
TO 6.
6.
While pulling the outside handle, remove door key cylinder
assembly (driver side) or outside handle escutcheon (passenger
side).
7.
While pulling outside handle, slide toward rear of vehicle to
remove outside handle.
8.
Remove the front gasket and rear gasket.
PIIA3553E
PIIA3554E
PIIA3555E
PIIA3557E
BL-164
DOOR LOCK
9.
Remove the TORX bolts (T30), remove the door lock assembly.
10. Remove the TORX bolt (T30) of the outside handle bracket.
11. While pulling outside handle bracket, slide toward rear of vehicle
to remove outside handle bracket and door lock assembly.
12. Disconnect the door lock actuator connector.
13. Reach to separate the key cylinder rod and outside handle cable
connection.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install each rod, be sure to rotate the rod holder until a click is felt.
PIIA1090E
PIIA3556E
PIIA3558E
PIIA3559E
TRUNK LID
BL-165
C
D
E
F
G
H
J
K
L
M
A
B
BL
TRUNK LID
PFP:H4300
Fitting Adjustment
NIS000CD
LONGITUDINAL AND LATERAL CLEARANCE ADJUSTMENT
1.
With the striker released, loosen the trunk lid hinge mounting bolts to close the trunk lid.
2.
Make the lateral clearance and the clearance to the rear window glass equal, and open the trunk lid to
tighten the mounting bolts to the specified torque.
SURFACE HEIGHT ADJUSTMENT
1.
Loosen the striker mounting bolts. Raise the striker to the top position, and temporarily tighten the upper
mounting bolt at the position.
2.
Loosen the bumper rubber collar, and the damper is drawn out.
3.
Close the trunk lid lightly and adjust the surface height, then open the trunk lid to finally tighten the striker
mounting bolts to the specified torque or bumper rubber collar is tighten by the hand.
1.
Trunk lid
2.
Rear fender
3.
Rear combination lamp
4.
Rear bumper facie
5.
Trunk lid striker
PIIA3548E
BL-166
TRUNK LID
Removal and Installation of Trunk Lid Assembly
NIS000CE
REMOVAL
1.
Disconnect the connector in the trunk lid, and remove the harness clamps to pull the harness out of the
trunk lid.
2.
Insert flat-bladed screwdriver into the gap and remove holder.
3.
Remove trunk lid stay.
4.
Remove the mounting bolts, and remove the trunk lid assembly.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
●
Operate with two workers, because of its heavy weight.
●
After installing, apply touch-up paint (the body color) onto the head of the hinge mounting bolts.
●
After installing, check the trunk lid adjustment. Refer to
Removal and Installation of Trunk Lid Stay
NIS000CF
REMOVAL
1.
Insert flat-bladed screwdriver into the gap and remove holder.
2.
Remove trunk lid stay on the trunk lid.
3.
Remove the stud bolts, and trunk lid stay.
1.
Trunk lid assembly
2.
Rear spoiler
3.
Emergency lever
PIIA3549E
SIIA1561E
PIIA4138E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст