Infiniti G35 (V35). Manual — part 114
HEATER & COOLING UNIT ASSEMBLY
ATC-127
C
D
E
F
G
H
I
K
L
M
A
B
ATC
*: With left and right ventilation temperature separately control system.
19.
Insulator
20.
Heater case (right)
21.
Low-pressure pipe 2
22.
O-ring
23.
High-pressure pipe 2
24.
Expansion valve
25.
Evaporator
26.
Heater case (left)
27.
Foot duct (left)
28.
Center case*
29.
Max. cool door (left)
*
30.
Ventilator door
31.
Side link
32.
Mode door motor
33.
Max. cool door
(Without left and right ventilation tem-
perature separately control system)
34.
Defroster door
35.
Max. cool door (right)
*
36.
Defroster door lever
37.
Defroster door link
: N·m (kg-m, in-lb)
: Always replace after every disassembly
ATC-128
HEATER CORE
HEATER CORE
PFP:27140
Removal and Installation
NJS00048
REMOVAL
1.
Remove heater & cooling unit assembly. Refer to
ATC-124, "HEATER & COOLING UNIT ASSEMBLY"
.
2.
Remove mounting screws, and then remove heater pipe cover.
3.
Remove mounting clips, and then remove foot duct (left).
4.
Slide heater core to leftward.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA4205E
MODE DOOR MOTOR
ATC-129
C
D
E
F
G
H
I
K
L
M
A
B
ATC
MODE DOOR MOTOR
PFP:27731
Removal and Installation
NJS00049
REMOVAL
1.
Remove blower unit. Refer to
2.
Remove mounting screws, and then remove mode door motor.
3.
Disconnect mode door motor connector.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA0954E
ATC-130
AIR MIX DOOR MOTOR
AIR MIX DOOR MOTOR
PFP:27732
Removal and Installation
NJS0004A
REMOVAL
Passenger Side
1.
Set the temperature control dial (passenger side) at 18
°
C (60
°
F), and then disconnect the battery cable
from the negative terminal.
2.
Remove blower unit. Refer to
.
3.
Remove mounting screws, and then remove air mix door motor.
4.
Disconnect air mix door motor connector.
Driver Side (With Left and Right Ventilation Temperature Separately Control System)
1.
Set the temperature control dial (driver side) at 18
°
C (60
°
F), and then disconnect the battery cable from
the negative terminal.
2.
Remove instrument driver lower panel. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
.
3.
Disconnect accelerator pedal position sensor connector.
4.
Remove mounting screws, and then remove air mix door motor.
5.
Disconnect air mix door motor connector.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA0955E
RJIA0956E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст