Infiniti G35 (V35). Manual — part 635
MT-8
DESCRIPTION
TRIPLE-CONE SYNCHRONIZER
The 1st, 2nd and 3rd gears is equipped with a triple-cone synchro-
nizer to reduce the operating force of the shift lever.
PCIB1432E
M/T OIL
MT-9
D
E
F
G
H
I
J
K
L
M
A
B
MT
M/T OIL
PFP:KLD20
Changing M/T Oil
NCS000AM
DRAINING
1.
Start the engine and warm up the transmission unit sufficiently.
2.
After stopping engine, remove filler plug and drain plug to drain oil.
3.
Replace gasket on drain plug with new one. Screw drain plug into transmission case, and tighten to the
specified torque. Refer to
.
CAUTION:
Do not reuse gasket.
FILLING
1.
Fill new oil into the transmission to the level of the filler plug mounting hole.
2.
Replace gasket on filler plug with new one. Screw filler plug into transmission case, and tighten to the
specified torque. Refer to
.
CAUTION:
Do not reuse gasket.
Checking M/T Oil
NCS000AN
OIL LEAKAGE AND OIL LEVEL
●
Check if oil is leaking from transmission or around it.
●
Check oil level from filler plug mounting hole as shown in the fig-
ure.
CAUTION:
Never start engine while checking oil level.
●
When screwing in filler plug with a new gasket, first screw into
the transmission by hand, then tighten to the specified torque.
Refer to
.
CAUTION:
Do not reuse gasket.
Oil grade and viscosity
MA-10, "RECOMMENDED FLUIDS AND LUBRICANTS"
Oil capacity
: Approx. 2.9 (3-1/8 US qt, 2-1/2 lmp qt)
PCIB0268E
MT-10
REAR OIL SEAL
REAR OIL SEAL
PFP:33140
Removal and Installation
NCS000AO
REMOVAL
1.
Remove propeller shaft. Refer to
PR-4, "Removal and Installation"
2.
Remove rear oil seal using oil seal puller.
INSTALLATION
1.
Apply multi-purpose grease to rear oil seal lip. Drive in rear oil
seal until the edge is approximately 1.2 - 2.2 mm (0.047 - 0.087
in) above the boss edge using drift.
CAUTION:
●
Do not reuse rear oil seal.
●
When installing, do not tilt oil seal.
2.
Install propeller shaft. Refer to
PR-4, "Removal and Installation"
.
CAUTION:
●
If lubricant leak has occurred during the repair work, check oil level after finishing work. Refer
to
.
Tool number
: KV381054S0 (
—
)
PCIB0194E
Tool number
: ST33400001 (J-26082)
PCIB0267E
POSITION SWITCH
MT-11
D
E
F
G
H
I
J
K
L
M
A
B
MT
POSITION SWITCH
PFP:32005
Checking
NCS000AP
COMPONENT LOCATION
BACK-UP LAMP SWITCH
●
Check continuity.
PARK/NEUTRAL POSITION SWITCH
●
Check continuity.
PCIB1384E
Gear position
Continuity
Reverse
Yes
Except reverse
No
SCIA0645E
Gear position
Continuity
Neutral
Yes
Except neutral
No
SCIA0645E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст