Infiniti G35 (V35). Manual — part 457
CENTER MUD GUARD
EI-23
C
D
E
F
G
H
J
K
L
M
A
B
EI
CENTER MUD GUARD
PFP:76850
Removal and Installation
NIS000GT
REMOVAL
1.
Remove center mud guard finisher. Refer to
.
2.
Remove screws on front, rear and lower side of center mud guard.
3.
Disconnect clips on back side of center mud guard.
4.
Remove center mud guard.
INSTALLATION
Install in the reverse order of removal.
PIIA3582E
1.
Center mud guard
2.
Center mud guard rear
EI-24
WINDSHIELD MOLDING
WINDSHIELD MOLDING
PFP:72700
Removal and Installation
NIS000GU
REMOVAL
Remove windshield molding. Refer to
NOTE:
●
Apply protective tape around circumference of windshield.
●
Guiding a cutter knife along glass, cut surface of molding.
●
Using pliers, draw out all remaining molding left in flanged area of body, and remove it completely from
adhering surface on glass.
INSTALLATION
Install windshield molding. Refer to
NOTE:
●
Align matching marks on body and glass. Install glass to body.
PIIB0098E
1.
Dam rubber
2.
Molding (upper)
3.
Fastener
4.
Mirror base
5.
Insulator
6.
Spacer
7.
Windshield glass
8.
Bond
WINDSHIELD MOLDING
EI-25
C
D
E
F
G
H
J
K
L
M
A
B
EI
●
Press entire surface of glass lightly to fit it completely.
Using a spatulaq, repair any adhesive overflow or shortage to make surface smooth. Position windshield
moldings and allow their adhesion.
CAUTION:
●
Be sure to install windshield molding before adhesive hardens.
●
After installing glass, keep door windows open and avoid driving vehicle until adhesive has com-
pletely cured.
EI-26
REAR WINDOW MOLDING
REAR WINDOW MOLDING
PFP:79762
Removal and Installation
NIS000GV
REMOVAL
Remove rear window molding. Refer to
GW-13, "REAR WINDOW GLASS AND MOLDING"
.
NOTE:
Apply a strip of protective tape along the contour of rear window glass (molding) to prevent paint surface from
being damaged.
INSTALLATION
Install rear window molding. Refer to
GW-13, "REAR WINDOW GLASS AND MOLDING"
.
NOTE:
●
Clean adhesive portion of rear window glass and around circumference with white gasoline.
●
Apply dam rubber to upper and lower surfaces of glass.
●
Attach rear window molding to side face of glass.
●
Rear window molding should not overlap on the surface of rear window glass.
PIIA3454E
1.
Rear window glass
2.
Dam rubber (upper)
3.
Spacer
4.
Dam rubber (lower)
5.
Molding (side)
6.
Bond
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст