Infiniti G35 (V35). Manual — part 111
AMBIENT SENSOR
ATC-115
C
D
E
F
G
H
I
K
L
M
A
B
ATC
AMBIENT SENSOR
PFP:27722
Removal and Installation
NJS0003X
REMOVAL
1.
Remove front grille. Refer to
2.
Disconnect ambient sensor connector, and then remove ambi-
ent sensor.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA1868E
ATC-116
IN-VEHICLE SENSOR
IN-VEHICLE SENSOR
PFP:27720
Removal and Installation
NJS0003Y
REMOVAL
1.
Remove instrument driver lower panel. Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
.
2.
Remove mounting screw, and then remove in-vehicle sensor.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA3584E
SUNLOAD SENSOR
ATC-117
C
D
E
F
G
H
I
K
L
M
A
B
ATC
SUNLOAD SENSOR
PFP:27721
Removal and Installation
NJS0003Z
REMOVAL
1.
Remove front defroster grille (LH). Refer to
IP-10, "INSTRUMENT PANEL ASSEMBLY"
.
2.
Disconnect sunload sensor connector, and then remove sunload
sensor.
INSTALLATION
Installation is basically the reverse order of removal.
RJIA0925E
ATC-118
INTAKE SENSOR
INTAKE SENSOR
PFP:27723
Removal and Installation
NJS00040
REMOVAL
1.
Remove low-pressure pipe 2 and high-pressure pipe 2. Refer to
ATC-144, "Removal and Installation of
Low-pressure Pipe 2 and High-pressure Pipe 2"
CAUTION:
Cap or wrap the joint of evaporator, low-pressure pipe 1 and high-pressure pipe 2 with suitable
material such as vinyl tape to avoid the entry of air.
2.
Slide evaporator to passenger side, and then remove intake
sensor.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
●
Replace O-rings of low-pressure pipe 1, 2 and high-pressure pipe 1, 2 with new ones, and then
apply compressor oil to it when installing it.
●
Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sen-
sor can be located in the same position.
●
Female-side piping connection is thin and easy to deform. Slowly insert the male-side piping
straight in axial direction.
●
Insert piping securely until a click is heard.
●
After piping connection is completed, pull male-side piping by hand to make sure that connection
does not come loose.
●
When recharging refrigerant, check for leaks.
RJIA0928E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст