Infiniti G35 (V35). Manual — part 759
SE-138
FRONT SEAT
7.
Open the space between walk-in side lever and walk-in side
lever finisher.
8.
Remove snap ring, and then remove walk-in side lever.
9.
Remove screw, and then remove walk-in side lever finisher.
10. Remove the stay securing the inner cloth.
11. From the back of the seatback, press the headrest holder tab of
the stay pipe hole to disengage. Then pull the headrest holder
up to remove.
NOTE:
Before installing the headrest holder, check its orientation (front/
rear and right/left).
12. Remove the seat heater harness connector. After removing the seatback trim and pad, remove the hog
rings to separate the trim, pad and seatback heater unit.
Assembly
Assemble in the reverse order of disassembly.
REMOVAL OF SEATBACK ASSEMBLY
1.
After completing the steps 1, 2 and 3 of “SEATBACK TRIM AND PAD”, remove the harness connectors
for the side air bag from the seat cushion.
2.
Remove the reclining device mounting bolts on the seatback frame, and remove the seatback assembly.
NOTE:
When assembling the seatback frame, make sure that the reclining device are locked on both sides, and
be sure to temporarily tighten the bolts, then tighten them finally.
INSTALLATION OF SEATBACK ASSEMBLY
Install in the reverse order of removal.
SEAT CUSHION TRIM AND PAD
CAUTION:
Do not disassemble front passenger seat cushion assembly.
Always replace as an assembly.
For front passenger seat service parts, refer to the service part catalogue.
PIIB4819E
PIIA1157E
PIIA0164E
FRONT SEAT
SE-139
C
D
E
F
G
H
J
K
L
M
A
B
SE
Disassembly
1.
Pull up tabs of reclining lever knob inside. Slide knob forward to
remove.
2.
Remove the seat cushion front finisher and seat cushion outer
finisher.
3.
Remove the power seat switch assembly.
4.
Remove the retainer on the seat cushion frame, then remove the harness connector for the seat heater.
5.
After removing the seat cushion trim and pad, remove the hog rings to separate the trim and pad and the
seat cushion heater unit.
Assembly
Assemble in the reverse order of disassembly.
PIIA1161E
PIIA3805E
PIIA3656E
SE-140
REAR SEAT
REAR SEAT
PFP:88300
Removal and Installation
NIS000IP
REMOVAL
Raise the bottom of the seat cushion to release the wire from the
plastic hook, then pull the seat cushion forward to remove.
INSTALLATION
Install in the reverse order of removal.
1.
Seatback board
2.
Seatback frame
3.
Seatback device lock indicator
4.
Seatback trim
5.
Seat cushion pad
6.
Seatback device cable
7.
Seatback device lock
8.
Seat cushion trim
9.
Seat cushion pad
10. Center tray cup holder
11. Center tray box lid
12. Center tray box
PIIA3612E
SIIA0517E
SRS-1
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
H RESTRAINTS
CONTENTS
C
D
E
F
G
I
J
K
L
M
SECTION
A
B
SRS
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
PRECAUTIONS . . . . . . . . . . . . . . .. 3
PREPARATION . . . . . . . . . . . . . . ... 4
Commercial Service Tools . . . . . . . . . . 4
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) . ... 5
TROUBLE DIAGNOSIS . . . . . . . . . . . .. 9
Trouble Diagnosis Introduction . . . . . . . . . 9
Self-Diagnosis Function (Without CONSULT-II) . . 19
SRS Operation Check . . . . . . . . . . . 20
DIAGNOSTIC PROCEDURE 1 . . . . . . ... 20
Trouble Diagnosis with CONSULT-II . . . . . .. 22
Trouble Diagnosis without CONSULT-II . . . . . 35
DIAGNOSTIC PROCEDURE 6 . . . . . . ... 35
WARNING LAMP FLASH CODE CHART . . ... 35
Trouble Diagnosis: “AIR BAG” Warning Lamp Does
Not Turn OFF . . . . . . . . . . . . . . . 39
DIAGNOSTIC PROCEDURE 7 . . . . . . ... 39
Trouble Diagnosis: “AIR BAG” Warning Lamp Does
Not Turn ON . . . . . . . . . . . . . . ... 40
DIAGNOSTIC PROCEDURE 8 . . . . . . ... 40
Trouble Diagnosis: Passenger Seatbelt Warning
System . . . . . . . . . . . . . . . . . 41
DRIVER AIR BAG MODULE . . . . . . . . . 42
Removal and Installation . . . . . . . . . . 42
REMOVAL . . . . . . . . . . . . . . ... 42
INSTALLATION . . . . . . . . . . . . ... 43
SPIRAL CABLE . . . . . . . . . . . . . . 44
Removal and Installation . . . . . . . . . . 44
REMOVAL . . . . . . . . . . . . . . ... 44
INSTALLATION . . . . . . . . . . . . ... 45
FRONT PASSENGER AIR BAG MODULE . . . .. 46
Removal and Installation . . . . . . . . . . 46
REMOVAL . . . . . . . . . . . . . . ... 46
INSTALLATION . . . . . . . . . . . . ... 46
SIDE CURTAIN AIR BAG MODULE . . . . . . 47
Removal and Installation . . . . . . . . . . 47
REMOVAL . . . . . . . . . . . . . . ... 47
INSTALLATION . . . . . . . . . . . . ... 48
CRASH ZONE SENSOR . . . . . . . . . . ... 49
Removal and Installation . . . . . . . . . . 49
REMOVAL . . . . . . . . . . . . . . ... 49
INSTALLATION . . . . . . . . . . . . ... 49
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст