Infiniti G35 (V35). Manual — part 719
SC-12
STARTING SYSTEM
Wiring Diagram — START —
NKS000EY
M/T MODELS
TKWM2603E
STARTING SYSTEM
SC-13
C
D
E
F
G
H
I
J
L
M
A
B
SC
TKWM2180E
SC-14
STARTING SYSTEM
A/T MODELS
TKWM2181E
STARTING SYSTEM
SC-15
C
D
E
F
G
H
I
J
L
M
A
B
SC
Trouble Diagnosis with Battery/Starting/Charging System Tester (Starting)
NKS000EZ
NOTE:
To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be done
as a set from start to finish.
1.
Turn off all loads on the vehicle electrical system.
2.
Perform battery test with Battery/Starting/Charging system
tester. Refer to
SC-6, "Trouble Diagnoses with Battery/Starting/
Charging System Tester (Battery)"
3.
Press “ENTER” to begin the starting system test.
4.
Start the engine.
5.
Diagnostic result is displayed on the tester. Refer to
"DIAGNOSTIC RESULT ITEM CHART"
.
NOTE:
●
If the starter performs normally but the engine does not start,
perform engine diagnosis.
●
For intermittent “NO CRANK” or “NO STARTER OPERA-
TION” incidents, refer to
.
DIAGNOSTIC RESULT ITEM CHART
SEL408X
SEL409X
SEL410X
Diagnostic item
Service procedure
CRANKING VOLTAGE NORMAL
Go to
CRANKING VOLTAGE LOW
CHARGE BATTERY
Perform the slow battery charging procedure. (Initial rate of charge is 10A for 12 hours.) Per-
form battery test again with Battery/Starting/Charging system tester. Refer to
Diagnoses with Battery/Starting/Charging System Tester (Battery)"
.
REPLACE BATTERY
Before replacing battery, clean the battery cable clamps and battery posts. Perform battery
test again with Battery/Starting/Charging system tester. Refer to
with Battery/Starting/Charging System Tester (Battery)"
. If second test result is “REPLACE
BATTERY”, then do so. Perform battery test again to confirm repair.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст