Infiniti G35 (V35). Manual — part 772
SRS-50
SIDE AIR BAG (SATELLITE) SENSOR
SIDE AIR BAG (SATELLITE) SENSOR
PFP:98830
Removal and Installation
NHS00023
REMOVAL
CAUTION:
●
Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3
minutes.
●
Do not use air tools or electric tools for servicing.
1.
Remove seat belt pre-tensioner. Refer to
and
SB-4, "Removal and Installation
2.
Remove side air bag (Satellite) sensor fixing nuts.
3.
Remove the side air bag (Satellite) sensor connector.
CAUTION:
●
Do not use old nuts; replace with new ones.
●
Check side air bag (Satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it
shows any visible signs of damage, replace it with new one.
●
Do not disassemble side air bag (Satellite) sensor.
●
Replace side air bag (Satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
●
Check side air bag (Satellite) sensor for proper installation.
●
After replacement of side air bag (Satellite) sensor, perform self-diagnosis to make sure that no
malfunction is detected. Refer to
PHIA0226E
FRONT SEAT BELT PRE-TENSIONER
SRS-51
C
D
E
F
G
I
J
K
L
M
A
B
SRS
FRONT SEAT BELT PRE-TENSIONER
PFP:86884
Removal and Installation
NHS00024
For removal and installation procedures, refer to
SRS-52
DIAGNOSIS SENSOR UNIT
DIAGNOSIS SENSOR UNIT
PFP:28556
Removal and Installation
NHS00025
REMOVAL
CAUTION:
●
Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3
minutes.
●
Do not use air tools or electric tools for servicing.
1.
Disconnect each harness connector for the air bag module and seat belt pre-tensioner.
2.
Remove center console. Refer to
IP-15, "(Y) Center Console Assembly"
3.
Disconnect diagnosis sensor unit connector.
4.
Remove hex bolts and ground bolt from the diagnosis sensor
unit.
CAUTION:
●
Do not use old bolts. Replace with new ones.
●
Check diagnosis sensor unit bracket to ensure it is free of deformities, dents, cracks or rust. If it
shows any visible signs of damage, replace with new one.
●
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
●
Check the diagnosis sensor unit for proper installation.
●
After replacement of diagnosis sensor unit, perform self-diagnosis to make sure that no malfunc-
tion is detected. Refer to
ECU DISCRIMINATED NO.
After replacing the diagnosis sensor unit, confirm that the diagnosis sensor unit identification is correct for the
vehicle as equipped.
PHIA0246E
Specification
ECU DISCRIMINATED No.
2WD Models with driver and passenger air bags, seat belt pre-tensioner, side air bags and curtain air
bags
FADFH
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT
SRS-53
C
D
E
F
G
I
J
K
L
M
A
B
SRS
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT
PFP:98852
Removal and Installation
NHS00026
The occupant classification control unit, occupant classification sensor, and bladder are an integral part of the
front passenger seat cushion and are replaced as an assembly. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст