Infiniti G35 (V35). Manual — part 386
DTC P0444, P0445 EVAP CANISTER PURGE VOLUME CONTROL SOLENOID
VALVE
EC-425
C
D
E
F
G
H
I
J
K
L
M
A
EC
Removal and Installation
NBS000T0
EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
Refer to
EC-426
DTC P0447 EVAP CANISTER VENT CONTROL VALVE
DTC P0447 EVAP CANISTER VENT CONTROL VALVE
PFP:14935
Component Description
NBS000T1
The EVAP canister vent control valve is located on the EVAP canis-
ter and is used to seal the canister vent.
This solenoid valve responds to signals from the ECM. When the
ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the canister vent. The ability to seal
the vent is necessary for the on board diagnosis of other evaporative
emission control system components.
This solenoid valve is used only for diagnosis, and usually remains
opened.
When the vent is closed, under normal purge conditions, the evapo-
rative emission control system is depressurized and allows “EVAP
Control System” diagnosis.
CONSULT-II Reference Value in Data Monitor Mode
NBS000T2
Specification data are reference values.
On Board Diagnosis Logic
NBS000T3
PBIB1263E
PBIB1086E
MONITOR ITEM
CONDITION
SPECIFICATION
VENT CONT/V
●
Ignition switch: ON
OFF
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
P0447
0447
EVAP canister vent con-
trol valve circuit open
An improper voltage signal is sent to ECM
through EVAP canister vent control valve.
●
Harness or connectors
(The valve circuit is open or shorted.)
●
EVAP canister vent control valve
DTC P0447 EVAP CANISTER VENT CONTROL VALVE
EC-427
C
D
E
F
G
H
I
J
K
L
M
A
EC
DTC Confirmation Procedure
NBS000T4
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm battery voltage is more than 11V at idle.
WITH CONSULT-II
1.
Turn ignition switch ON.
2.
Select “DATA MONITOR” mode with CONSULT-II.
3.
Start engine and wait at least 8 seconds.
4.
If 1st trip DTC is detected, go to
EC-429, "Diagnostic Procedure"
.
WITH GST
Follow the procedure “WITH CONSULT-II” above.
SEF058Y
EC-428
DTC P0447 EVAP CANISTER VENT CONTROL VALVE
Wiring Diagram
NBS000T5
TBWM1119E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст