Volkswagen Golf / Golf GTI / Jetta. Manual — part 253
28-32
Test requirements
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Knock sensor malfunction
detected by On Board
Diagnostic (OBD)
Page 01-
23
.
The signal from brake light
switch and brake pedal switch
must be OK, Checking
Page
24-206
.
Engine Coolant Temperature
(ECT) must be at least 85 C,
display group 28, display zone
3.
Ignition system, servicing
28-33
Functional check
- Connect VAG 1551 Scan tool ((VAG 1552) and
select engine electronics control module with
"Address word" 01. Engine must be running at
idling speed: (Connecting scan tool and
selecting engine electronics control module
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -4- for function "Initiate
basic setting" and confirm entry with -Q- button.
Basic setting
Input display group number XXX
Indicated on display:
- Press buttons -0-, -2- and -8- for "Display group
number 28" and confirm entry with -Q- button.
System in basic setting 28
1
2
3
4
Indicated on display: (1 to 4
display zones)
Only continue with the test when
The Engine Coolant Temperature (ECT) is
above 85 C - Display zone 3-
Ignition system, servicing
28-34
- Depress brake pedal and hold.
- Depress accelerator down to wide open throttle
position.
Engine speed will be increased by Engine
Control Module (ECM) to approx. 2300 rpm.
- Depress brake pedal and accelerator and hold
until display in display zone 4 jumps from "Test
OFF" to "Test ON".
- Depress and hold brake pedal and accelerator
until display zone 4 displays specification "Syst.
OK."
- Release brake and accelerator pedals.
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
If "Syst.n.OK." appears in display zone 4:
- Check resistance and wiring for knock sensors
Page 28-35
.
Ignition system, servicing
28-35
Checking resistance and wiring
Knock Sensor (KS) 1 -G61-
- Separate 3-pin connector to
Knock Sensor (KS) 1 -G61-
(arrow) on right of cylinder head.
- Measure resistance between
terminals 1 and 2, 1 and 3, and 2
and 3 at connector to Knock
Sensor (KS) 1 -G61-.
Specification:
Ignition system, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст