Volkswagen Golf / Golf GTI / Jetta. Manual — part 254
28-36
Knock Sensor (KS) 2 -G66-
- Disconnect 2-pin connector from
Knock Sensor (KS) 2 -G66-
(arrow)(on intake side of cylinder
head).
- Measure resistance between
terminals 1 and 2 at connector to
Knock Sensor (KS) 2 -G66-.
Specification:
Ignition system, servicing
28-37
If the specifications are not obtained:
- Replace Knock Sensor (KS) -G61- or -G66
Page 28-4
, item 7 or
Page 28-8
, item 17 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
.
If the specifications are obtained:
- Remove wiper arms and cowl panel:
Repair Manual, Electrical Equipment; Repair
Group 92
- Connect VAG 1598/31 test box to control
module wiring harness. Engine Control Module
(ECM) remains disconnected.
Ignition system, servicing
28-38
Knock Sensor (KS) 1 -G61-
Knock Sensor (KS) 2 -G66-
- Check wiring for open circuit
between test box and 3-pin
connector referring to Electrical
Wiring Diagrams
terminal 1 and socket 106
terminal 2 and socket 99
terminal 3 and socket 108
Wire resistance: max. 1.5
- Additionally check wires for short
to one another.
Specification:
- Check wiring for open circuit
between test box and 2-pin
connector referring to Electrical
Wiring Diagrams.
terminal 1 and socket 107
terminal 2 and socket 99
Wire resistance: max. 1.5
- Additionally check wires for short
to one another.
Specification:
Ignition system, servicing
28-39
If no wiring malfunction is detected:
- Loosen knock sensor and tighten again to 20
Nm.
- Repeat functional check.
- Check control module DTC memory again.
If malfunction is still present:
- Replace Knock Sensor (KS) -G61- or -G66-
Page 28-4
, item 7 or
Page 28-8
, item 17 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Engine Control
Module (ECM) was disconnected from battery
positive, readiness code must be generated
again
Page 01-149
.
Ignition system, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст