Volkswagen Golf / Golf GTI / Jetta. Manual — part 1139
96-7
Power Window Regulator Switches in
front passenger's door/rear doors,
removing and installing
Note:
The procedure for removing and installing the
Right Front Power Window Regulator Switch -
E41-
Left Rear Power Window Regulator Switch -
E52-
Right Rear Power Window Regulator Switch -
E54-
is essentially the same for all switches.
The following illustrates the procedure for -E41-.
Removing
CAUTION!
Before beginning repairs on the electrical
system:
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Removing (appropriate) door trim
Repair Manual, Body Interior, Repair Group
70
- Disconnect electrical connector at switch
module.
Interior lights and switches
13/2/2005
96-8
Installing
Install in reverse order of removal.
- Bend mounting frame -B- out on
the longer switch side -A- and
remove switch from mounting
frame.
Interior lights and switches
13/2/2005
96-9
Mirror Adjustment Switch -
E43- with Mirror Adjustment
Selection Switch -E48-,
removing and installing
Removing
CAUTION!
Before beginning repairs on the
electrical system:
Switch off all electrical
consumers.
Switch ignition off and remove
ignition key.
- Removing front door trim
Repair Manual, Body Interior,
Repair Group 70
- Disconnect electrical connector.
Installing
Install in reverse order of removal.
- Bend mounting frame -B- out on
the longer switch side -A- and
remove from mounting frame.
Interior lights and switches
13/2/2005
96-10
Switches in instrument panel, removing
and installing
Switches consists of a switch housing and trim
plate with relevant symbol. The trim plate is
clipped onto the switch housing. If the trim is
released instead of the switch during removal,
the trim must be re-clipped onto the switch
housing afterwards.
Remove switches with connected wiring from
instrument panel opening prior to disconnecting
electrical connection on rear of switch.
If necessary, temporarily remove switch to the
left of of the switch to be removed/replaced to
allow sufficient access to the wiring.
Switch blank-out covers (where applicable) are
removed in the same manner as switches.
CAUTION!
Be careful not to damage instrument panel
when removing switch. Protect trim in area of
switch with adhesive tape before removing
switch.
Do Not pry out switches from the side. Only
pull out from the top.
Interior lights and switches
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст