Volkswagen Golf / Golf GTI / Jetta. Manual — part 1137
94-68
Installing
Install in reverse order of removal, noting the
following:
- Push ignition/starter switch into steering lock
housing.
Note:
When installing the ignition/starter lock switch
ensure that the ignition/starter lock switch and
the lock cylinder are in the same position, e.g.
"ignition on".
- Tighten securing screws and seal with locking
paint.
- Connect electrical connector to ignition/starter
switch.
- Reinstall steering column switches and steering
wheel.
Ignition/starter switch and lock cylinder
13/2/2005
94-69
Ignition/starter switch,
connector assignments
Connector, 8 pin
1 - Terminal 50 (starter)
2 - Terminal 75 ("X - relief"contact)
3 - Terminal 30 (Ground)
4 - Terminal P
5 - Terminal 50b
6 - Terminal 15 (Ignition ON)
7 - Terminal 30 (B+)
8 - Terminal 86s (Key warning
buzzer)
Ignition/starter switch and lock cylinder
13/2/2005
96-1
Interior lights and
switches
Light Switch -E1-, removing
and installing
Removing
CAUTION!
Before beginning repairs on the
electrical system:
Switch off all electrical
consumers.
Switch ignition off and remove
ignition key.
Installing
- Turn rotary switch to "0" position.
- Press rotary part inward -arrow1-
and turn slightly to right -arrow2-
- Hold rotary part in this position
and pull light switch out from
instrument panel -arrow3-.
- Disconnect electrical connection.
- Connect electrical connector.
- Hold light switch and press rotary
part inward -arrow1- and turn
slightly to right -arrow2-
- Hold rotary part in this position
and insert light switch into
instrument panel -arrow3-.
- Turn rotary part to position "0",
release and engage switch
Interior lights and switches
13/2/2005
96-2
Instrument Panel Light Dimmer/Switch
E20-, removing and installing
Note:
European-only market dimmer/switch that
includes manual headlight beam adjuster is
illustrated here. Procedure is the same for
USA/CDN models.
Removing
CAUTION!
Before beginning repairs on the electrical
system:
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
- Apply tape to instrument panel in area around
switch in order to protect instrument panel.
Installing
- Carefully pry out switch housing from installation
frame using screwdriver as illustrated.
- Pull out switch and disconnect electrical
connector.
- Connect electrical connector.
- Insert headlight adjuster in guide on mounting
frame and press in.
Interior lights and switches
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст