Volkswagen Golf / Golf GTI / Jetta. Manual — part 495
- Remove bolts - Arrows - .
The following steps apply to all vehicles.
- Mark installation position of bolts from ball joint to control
arm.
- Remove bolts - Arrows - .
- Disconnect drive axle from transmission axle flange.
- Pull wheel bearing housing with ball joint out from control
arm.
- Remove hex bolt - 3 - on control arm.
- Remove hex bolts - 1 - and - 2 - and take out control arm.
Front suspension, servicing
Vehicles with automatic transmission
- Push engine/transmission assembly forward with a lever.
- Remove hex bolt - 1 - and take out control arm.
Installing
Installation is carried out in reverse sequence.
- Install and fasten wheel
44-2, Tightening torques for
wheel bolts
.
Tightening torques:
Ball joint to control arm
Use new bolts!
20 Nm plus an additional
1
/
4
turn (90 )
Pendulum support to subframe
25 Nm
Forward bolt for control arm
Rearward bolt for control arm
Use new bolts!
70 Nm plus an additional
1
/
4
turn (90 )
Coupling rod to stabilizer bar
30 Nm
Drive shaft to flanged shaft
40-5,
Control arm bonded rubber bushing,
replacing
Front suspension, servicing
Special tools, testers and auxiliary items
required
n
Thrust plate VW401
n
Thrust plate VW402
n
Punch VW411
n
Thrust pad VW447 i
n
Sleeve VW516
n
Tube 30 - 14
Front suspension, servicing
Special tools, testers and auxiliary items
required
n
Support 40 - 103
n
Sleeve 2010
n
Press piece 3288/2
n
Assembly tool 3301
n
Torque wrench V.A.G1331
Front suspension, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст