Volkswagen Golf / Golf GTI / Jetta. Manual — part 607
50-2
Replacement part
Engine mount bracket
Preparing new part
Welding in place
- Drill 7 mm (0.275 in.) dia. holes
for SG-plug weld seam.
- Install new part using
straightening bracket.
- Weld mount bracket in place, SG-
plug weld seam.
- Weld in weld points -a- from
outside, SG-plug weld seam.
50 40 55 50 Engine mount bracket, replacing
13/2/2005
50-3
50 52 55 50
Intermediate
piece,
replacing
Cutting location
Note:
Offset parting cut
50 mm (1.96 in.) to
fender connecting
plate and
intermediate piece.
Partial repair:
If extent of damage
permits, parting
cuts can be
vertical.
Butt weld parting
cut, SG-continuous
weld seam.
- Separate original
joint.
50 52 55 50 Intermediate piece, replacing
13/2/2005
50-4
Replacement part
Welding in place
- Remove excess material.
Connecting plate
- Secure new part and check
gaps/mating lines with attaching
parts.
- Spot weld intermediate piece, RP-
spot weld seam.
- Weld in fender connecting plate
Page 50-7
.
50 52 55 50 Intermediate piece, replacing
13/2/2005
50-5
50 53 55 50
fender
connecting
plate,
replacing
Cutting location
Note:
Offset parting cut
50 mm (1.96 in.)
to fender
connecting plate
and wheel house
upper long
member.
Partial repair:
A partial repair is
possible using
parting cut -1-
shown.
- Cut out
connecting
plate.
- Separate
original joint.
50 53 55 50 fender connecting plate, replacing
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст