Volkswagen Golf / Golf GTI / Jetta. Manual — part 1196
91-85
Telematic Control Module -J499- - Jetta
Wagon, Golf & GTI, removing and
installing
Notes:
If the telematic control module is replaced, the
OnStar
system needs to be reconfigured
Page 91-95
.
Removing
Before beginning repairs on the electrical
system, disconnect battery!
Repair Manual, Electrical Equipment; Repair
Group 27; "Battery, disconnecting and
reconnecting".
DO NOT exchange Telephone/Telematic
Control Modules between vehicles! Each
module contains specific Station Identification
(STID) and Electronic Serial Number (ESN)
data unique to the VIN. This data is used by
OnStar
and National Cellular Telephone
Network to identify the vehicle and administer
the customer's account.
Using the VAS 5051 Vehicle Diagnostic Testing
and Information system in operating mode
"Guided Fault Finding, and function "-J499
Telematic control module, replacing" it is
possible to read the telematic control module
coding from the existing module before
removal. Note code prior to removal in order
input code into replacement control module.
- Remove luggage compartment floor panel (Jetta
Wagon) or carpet mat (Golf & GTI).
- Jetta Wagon: remove both storage trays
arrows-.
Telematics
13/2/2005
91-86
- Lift and remove tool/jack set
insert in direction of -arrow-.
- Remove screw -arrow- from
plastic retainer.
- Lift retainer as far as the electrical
harness allows.
- Remove lower part of retainer
base plate and remove telematic
control module.
Telematics
13/2/2005
91-87
- First disconnect 42-pin connection from control
module, as follows:
Installing
Install in reverse order of removal, noting the
following:
- Depress clip -arrow1- and slide locking lever in
direction of -arrow2-.
- Then disconnect antenna cable connections
from control module.
If telematics control module was replaced:
- When reinstalling plastic retainer, first insert/lay
into spare tire well as illustrated.
- Then, slide retainer forward (in direction of
arrow-) until the screw hole in the retainer lines
up with the threaded insert underneath.
- Insert screw into screw hole in retainer and
tighten.
- Code telematics control module
Page 91
- Reconfigure telematics system for OnStar
functions
Page 91-95
.
Telematics
13/2/2005
91-88
Telematic Control Module -J499- - Jetta
Sedan, removing and installing
Notes:
If the telematic control module is replaced, the
OnStar
system needs to be reconfigured
Page 91-95
.
Removing
Before beginning repairs on the electrical
system, disconnect battery!
Repair Manual, Electrical Equipment; Repair
Group 27; "Battery, disconnecting and
reconnecting".
DO NOT exchange Telephone/Telematic
Control Modules between vehicles! Each
module contains specific Station Identification
(STID) and Electronic Serial Number (ESN)
data unique to the VIN. This data is used by
OnStar
and National Cellular Telephone
Network to identify the vehicle and administer
the customer's account.
Using the VAS 5051 Vehicle Diagnostic Testing
and Information system in operating mode
"Guided Fault Finding, and function "-J499
Telematic control module, replacing" it is
possible to read the telematic control module
coding from the existing module before
removal. Note code prior to removal in order
input code into replacement control module.
- Loosen upper left luggage compartment trim and
pull down -arrows-.
Telematics
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст