Volkswagen Golf / Golf GTI / Jetta. Manual — part 1195
shelf.
Jetta
Wagon,
Golf &
GTI,
removing
and
installing
Page
91-85
.
Jetta
sedan,
removing
and
installing
Page
91-88
.
Control
module
multi-pin
connector
terminal
assignments
Page 91-
90
.
Telematics
13/2/2005
91-82
Telematic Control Head - OnStar
control buttons, description
The telematics control head is in the front
headliner ahead of the front interior light
module. The control head contains three
separate buttons as well as a system
telematics indicator lamp (LED).
The OnStar
("On
") button is used to
contact the OnStar
call center to request
various convenience services. It is also used
to initialize/activate the owner's subscription
to OnStar
services and/or update the
customer's account in the event that the
Telephone/Telematics Control Module
requires replacement.
The Emergency button is used to contact the
OnStar
call center to request emergency
services such as fire department, police etc.
The Communication ("DOT") button is used
to end a call to the OnStar
call center,
place or answer personal calls or cancel a
call if one of the other buttons is accidentally
pressed.
Note:
Use of certain OnStar
services requires a
subscriber's Personal Identification Number
(s) (PIN).
For complete system operation details
Volkswagen Telematics by OnStar
Owner's Manual.
Telematics
13/2/2005
91-83
Telematic Control Head - OnStar
telematics indicator lamp, description
The telematics indicator lamp is located between
the OnStar
and Communication buttons. The
green light comes on after a self-check routine is
performed (approx. 10- 15 seconds after ignition
is switched on)
Indications:
Green: Indicates system has passed self-test
and is ready to place or receive calls. Light
remains on even in areas without cellular
coverage.
Blinking green: Indicates a call has been
initiated or is in progress.
Red: Indicates system has not passed self-test
or indicates system malfunction.
Note:
Additional information and system
troubleshooting using telematics indicator lamp
Page 91-101
.
Telematics
13/2/2005
91-84
Telematic Control Head -E264-
, removing and installing
Removing
Before beginning repairs on the
electrical system, disconnect
battery!
Repair Manual, Electrical
Equipment; Repair Group 27;
"Battery, disconnecting and
reconnecting".
- Using appropriate screwdriver,
carefully unclip control head from
areas indicated with -arrows-.
CAUTION!
Telematic control head buttons
cannot be removed, dismantled or
serviced separately. Should
malfunctions occur, replace
complete control head.
Installing
Install in reverse order of removal.
- Remove control head in direction
of -arrows-.
- Disconnect electrical connection.
- Check telematic system coding
and recode if necessary
Page
91-93
.
Telematics
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст