Volkswagen Golf / Golf GTI / Jetta. Manual — part 67
19-31
Coolant fan, checking
Special tools and equipment
Test conditions
VAG 1594 A Adapter set
Wiring diagram
Main fuses must be OK.
Coolant Fan Control (FC)
Thermal switch -F18- is OK.
Cooling system components, servicing
19-32
Test sequence
- Remove left-hand insulation tray:
Repair Manual, Body Exterior, Repair Group
50
- Disconnect 3-pin connector from Coolant Fan
Control (FC) Thermal switch -F18-.
If 1st or 2nd speeds of fans do not run:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
If no wiring fault is detected:
- Bridge contact -1- and contact -2- of connector
using adapter cables from VAG 1594 A.
1st speed for Coolant fans -V7- and -V35
start.
- Switch ignition on.
- Bridge contact -2- and contact -3- of connector
with adapter cables from VAG 1594 A.
2nd speed for Coolant fans -V7- and -V35
start.
- Locate and eliminate open circuit referring to
wiring diagram:
- Replace Coolant fan -V7- or -V35-.
Cooling system components, servicing
19-33
After-Run Coolant pump -V51-,
checking
Special tools and equipment
VAG 1527 B Diode test lamp
VAG 1594 A Adapter set
Wiring diagram
Cooling system components, servicing
19-34
Test conditions
Test sequence
Repair Manual, Body Exterior,
Repair Group 50
Checking function
All fuses must be OK.
- Remove center insulation tray:
- Disconnect 2-pin connector from
After-Run Coolant pump -V51-
(arrow).
- Connect contacts of After-Run
Coolant pump -V51- to battery
using adapter cables from VAG
1594.
After-Run Coolant pump -V51-
must start.
Cooling system components, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст