Volkswagen Golf / Golf GTI / Jetta. Manual — part 746
disconnecting ignition- and Ground
(GND) wires. This is done e.g. by
briefly grasping chassis or door
striker.
- Disconnect harness connector - 2 - and
remove airbag unit - 1 - downward.
Installing
- Installation is reverse of removal.
- Switch ignition on.
- Close doors.
Caution!
Make sure no one is in vehicle.
- Connect battery Ground (GND) strap
Airbag
13/2/2005
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
Note:
n
If engine Electronic Control Module (ECM) is subject
to low voltage with ignition on, DTC memory and
Readiness code must be checked.
Repair Manual, OBD II Fuel Injection Ignition, Repair
Group 01,
Airbag control module -J234-, removing and
installing
Removing
- Disconnect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
- Remove trim/footwell - 5 - .
Caution!
Observe safety precautions for working on airbags
69-4, Safety precautions when working on airbags
.
Airbag
13/2/2005
- Fold bracket - 2 - opposite direction of - arrow - and
disconnect connector - 3 - from control module - 1 - .
- Remove nuts - 4 - (qty. 3, 6 Nm) and remove control
module from studs.
Installing
- Installation is reverse of removal.
- Switch ignition on.
Caution!
Make sure no one is in vehicle.
- Connect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
- If control module was replaced, it must be coded, adapt
(code) components
69-4, Components, adapting
.
Side curtain protection, driver and
passenger sides, assembly overview (Jetta)
Airbag
13/2/2005
1. Side curtain protection
¡
Removing
69-4, Side
curtain protection, driver and
passenger sides, removing
and installing (Jetta)
2. Catches
3. Side curtain guide
¡
Clipped in
4. Bolt
¡
Qty. 7
¡
5 Nm
5. Connector
Airbag
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст