Volkswagen Golf / Golf GTI / Jetta. Manual — part 745
- Remove hex bolts - 7 - (qty. 4, 2.5 Nm),
loosen airbag unit - 1 - from supports - 5 -
.
Caution!
Electrostatic charges may result in
involuntary deployment of airbag.
Therefore, mechanic must be
electrostatically discharged before
disconnecting ignition- and Ground
(GND) wires. This is done e.g. by
briefly grasping chassis or door
striker.
- Disconnect harness connector - 2 - and
remove airbag unit - 1 - from instrument
panel.
Installing
Airbag
13/2/2005
- Installation is reverse of removal.
- Switch ignition on.
Caution!
Make sure no one is in vehicle.
- Connect battery Ground (GND) strap
.
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
Note:
n
If engine Electronic Control Module (ECM) is subject
to low voltage with ignition on, DTC memory and
Readiness code must be checked.
Repair Manual, OBD II Fuel Injection Ignition, Repair
Group 01,
Front Passengers airbag unit (Instrument
panel without airbag seam), assembly
overview
Airbag
13/2/2005
1. Passengers airbag unit with
airbag igniter 1, Passengers side -
N131-
¡
Removing
69-4, Front
Passengers airbag unit
(Instrument panel without
airbag seam), removing and
installing
2. Connector
3. Central tube
4. Brace
¡
Always replace after airbag
has deployed.
5. Bolt
Airbag
13/2/2005
¡
Qty. 4, 2.5 Nm
6. Bolt
¡
Qty. 4, 2.5 Nm
Front Passengers airbag unit (Instrument
panel without airbag seam), removing and
installing
Removing
Caution!
Before working on electronic components, disconnect
battery ground (GND) strap.
Repair Manual, Electrical Equipment, Repair Group
27, disconnecting and connecting battery
- Disconnect battery Ground (GND) strap .
- Remove center console
68-2, Center console,
removing and installing
.
- Remove glove compartment
68-2, Glove compartment,
removing and installing
.
Caution!
Observe safety precautions for working on airbags
69-4, Safety precautions when working on airbags
.
- Remove four bolts - 5 - (2.5 Nm).
- Push out airbag unit - 1 - with two
supports - 4 - upward out of angle
brackets on central tube - 3 - .
- Press airbag unit - 1 - aside and lower
until harness connector - 2 - is accessible.
Caution!
Electrostatic charges may result in
involuntary deployment of airbag.
Therefore, mechanic must be
electrostatically discharged before
Airbag
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст