Volkswagen Golf / Golf GTI / Jetta. Manual — part 425
45-82
- Release secondary locking device
(violet) in direction of arrow with a
screwdriver.
ABS/EDS/ASR/ESP Mark 60
connector T47
Contact assignment of connector
T47 wiring harness/ ABS Control
Module (w/EDL) -J104-
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
ABS system components for front and rear axles, removing and installing
45-83
- Push out relevant contacts with
an ejection tool from wiring
harness repair kit VAS 1978.
- Separate connector from speed
sensor wiring and speed sensor.
- For vehicles with brake wear
indicator separate connector -1-.
- Unclip the wiring from retainer -2-.
- Remove faulty speed sensor
wiring and guide in new speed
sensor wiring.
- Connect speed sensor to speed
sensor wiring.
ABS system components for front and rear axles, removing and installing
45-84
Make sure the wiring is not twisted
when installing the speed sensor
wiring in the wheel housing.
- Clip in speed sensor wiring
(arrows).
- Insert brake wear indicator
connector into bracket on
suspension strut.
- Guide contacts into connector
housing.
- Push individual wiring seals in
onto stop with an insertion tool
from VAS 1978.
- Secure contacts with secondary
locking device and install multi-pin
connector cover cap.
ABS system components for front and rear axles, removing and installing
45-85
ABS system
components
for rear
axle, (Front
wheel drive)
removing
and
installing
1 - ABS
speed
sensor
Checked
by On
Board
Diagnostic
(OBD)
Before
inserting
sensor,
clean
mounting
hole inner
surface
and coat
with
lubricating
paste G
000 650
Disc
brakes
Page
45-88
2 - Hex
socket
head
bolt, 8
Nm (71
in lb)
3 - Stub
axle
4 - Splash
plate
5 - Wheel
ABS system components for front and rear axles, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст