Volkswagen Golf / Golf GTI / Jetta. Manual — part 653
55 - 1
Hood
Assembly overview
1. Hood
Removing
- Disconnect hoses for
windshield washer system
and remove washer
nozzles.
- Remove gas-filled strut
Item - 3 -
at lid.
- Unclip hinge cover
Item
- 12 -
and remove from
hinge.
- Remove bolts
Item - 10
Hood
13/2/2005
2. Stopper
¡
By threading out and in, lid can be
adjusted in height to fenders.
3. Gas-filled strut
¡
Removing and installing
55-1,
Gas-filled strut, removing
¡
Venting gas
55-2, Releasing gas
from gas-filled strut
4. Spacing device
5. Guide piece
6. Plenum chamber seal
¡
Inserted on flange
7. Clip
8. Hose/spray jet
¡
Removing
9. CW sealing piece
10. Bolt
¡
23 Nm
11. Hinge
12. Hinge cover
¡
Clipped
-
and remove lid.
- Adjusting
55-1, Hood,
adjusting
Repair Manual, Electrical Equipment,
Repair Group 92, Servicing windshield
washer system
Hood
13/2/2005
¡
Pull off at right angle
Hood, adjusting
- Hood can be aligned between fenders by sliding flap
hinge in elongated holes.
- With stop
Item - 2 -
, hood can be adjusted in height to
fenders.
Gap dimension Body panel gaps; Body, front
- After installation or adjustment work, corrosion protection
measure must be performed on hinge and bolts.
Gas-filled strut, removing
- Support hood.
- Lift securing clip - 1 - using a screwdriver and remove
gas-filled strut from ball studs - 2 - .
Note:
When re-using gas-filled strut, do not pry securing clip - 1 -
completely out of ball socket, otherwise securing clip may
be damaged.
1. Securing clip
2. Mounting bracket with ball studs
3. Gas-filled strut
Hood
13/2/2005
Bowden cable, removing and installing
1. Bowden cable
¡
Replace - remove operating lever
55-1, Release lever, removing and
installing
2. Sealing grommet
3. Expanding nut
4. Actuating lever
¡
Removing and installing
55-1,
Release lever, removing and
installing
5. Bolt
6. Mounting bracket
Hood
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст