Volkswagen Golf / Golf GTI / Jetta. Manual — part 196
24-38
Components, checking
Heated Oxygen Sensor (HO2S),
checking
Note:
The vehicle must be raised to gain access to
the Oxygen Sensor (O2S) connector.
Only gold plated terminals may be used to
repair the terminals in the Oxygen Sensor
(O2S) connectors.
Special tools and equipment
Note:
All functions which could previously be performed
with VAG 1551/1552 can also be performed with
the VAS 5051.
VAG 1551 Scan tool (or VAG 1552) with VAG
1551/3 adapter cable
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1594 Adapter set
VAG 1598/31 Test box
Electrical Wiring Diagrams
Components, checking
24-39
Test requirements
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be switched
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Fuel Pump (FP) relay -J17- must
be OK., checking:
Components, checking
24-40
Test sequence
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -4- and -1- for "Display group
number 41" and confirm entry with -Q- button.
Read measured value block 41
1
2
3
4
Indicated on display: (1...4
display zones)
- Check status of the Oxygen Sensor (O2S)
heating in display zone 2: Display: Htg.bC.ON /
Htg.bC.OFF (alternating):
Components, checking
24-41
Note:
The Oxygen Sensor (O2S) heating may be
switched on or off depending on the operating
conditions of the engine, therefore the display in
display zone 2 may show "Htg.bC.ON" or
alternating from "Htg.bC.ON" to "Htg.bC.OFF".
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
If the display does not indicate as described:
- Remove protective cover (arrows) and
disconnect 6-pin connector (black) -1- to Heated
Oxygen Sensor (HO2S) -G39-.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст