Volkswagen Golf / Golf GTI / Jetta. Manual — part 262
30-9
Removing
- Turn clutch pedal switch 45 to left and pull out
from support.
- Remove over-center spring
Page 30-5
- Separate clutch pedal from clutch master
cylinder
Page 30-14
and push operating rod
toward engine compartment onto stop.
Installing
Installation is performed in the reverse sequence.
Note the following:
- Remove nut -A-.
- Pull bolt out until clutch pedal can be removed.
The bearing bracket -A- must be installed to the
clutch master cylinder operating rod -B-.
- Push clutch pedal in direction of arrow to
engage it. Make sure it is secure.
- Install over center spring
Page 30-5
.
- Place clutch pedal switch in mounting hole and
turn 45 to the right.
Clutch mechanism, repairing
30-10
Hydraulic
components,
assembly
overview
1 - Brake
fluid
reservoir
2 - Supply
hose
3 - Clutch
master
cylinder
Removing
and
installing
Page
30-14
4 - Bearing
bracket
Only
replace
with
clutch
master
cylinder
removed
Remove
Fig. 1
Install
Fig.
2
5 - Clutch
pedal
Removing
and
installing
Page
30-8
6 - Hex nut,
self-
locking,
25 Nm
Clutch mechanism, repairing
Always
replace
Clutch mechanism, repairing
30-11
7 - Oil seal
Always
replace
Pull onto
line/hose
connection
Moisten
with
brake
fluid
before
installing
8 - Line/hose
assembly
Check
Parts
catalog for
application
9 - Bracket
Secured
to body
10 - Oil Seal
Always
replace
11 - Bleeder
12 - Oil Seal
Always
replace
Pull onto
line/hose
connection
Moisten
with
brake
fluid
before
installing
13 - Clip
To
remove
Clutch mechanism, repairing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст