Volkswagen Golf / Golf GTI / Jetta. Manual — part 261
30-5
Over-center spring, removing
and installing
Special tools and equipment
Removing
Repair Manual, Body Interior,
Repair Group 70
T10111 Assembly device
- Remove cover/lower drivers side.
- Insert assembly device T10111 in
over-center spring from right side.
- Make sure that assembly device
seats correctly on over-center
spring:
1 - Assembly device must fit exactly
onto over-center spring rear part,
with claws over bridge -1-.
2 - Lightly press clutch pedal in
direction of bulkhead.
Hang assembly device tab -2-
in over-center spring cut out.
Clutch mechanism, repairing
30-6
- Press clutch pedal to bulkhead until over-
spring can be taken out of support mountings
and clutch pedal.
- Make clutch pedal recede even more until it is in
rest position.
Installing
- Turn over-center spring together with assembly
device T10111 in direction of arrow -A- and take
out downward in direction of arrow -B-.
- Pull clutch pedal toward inside of vehicle.
- Install over-center spring together with assembly
device T10111 in direction of arrow -A- into
support. When doing this turn in direction of
arrow -B-.
Clutch mechanism, repairing
30-7
Repair Manual, Body Interior,
Repair Group 70
- Install over-center spring on
support in rear (arrow -A-).
- Press clutch pedal to bulkhead
until over-center spring lies
against clutch pedal bearing tab
(arrow -B-).
- Move clutch pedal to rest position,
and remove assembly device.
- Install cover/lower driver's side.
Clutch mechanism, repairing
30-8
Clutch pedal, removing and
installing
Special tools and equipment
T10005 Pliers
VAG 1331 Torque wrench
Clutch mechanism, repairing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст