Volkswagen Golf / Golf GTI / Jetta. Manual — part 540
Installing
- Install wheel bearing/wheel hub unit as far as possible on
stub axle.
- Attach special tool 3420 and pull wheel bearing/wheel hub
unit on to stop.
Caution!
Make sure that the hubs/wheel bearing unit does not
tilt!
- Remove assembly tool 3420 ab.
- Use a new 12-point nut - A - and tighten to 175 Nm.
- Install brake disc.
Wheel bearing, servicing
- Drive in dust cap.
Note:
n
Always replace dust caps.
n
Damaged (dented) dust caps allow ingress of
moisture, always use the tool illustrated. Always use
tool illustrated to reduce chance of damage to dust
cap.
Further installation in reverse order
- Install and fasten wheel
44-2, Tightening torques for
wheel bolts
.
Fastener/location
Tightening torque:
Brake caliper to rear axle
65 Nm
Wheel bearing/wheel hub on vehicles with
drum brakes, removing and installing
Wheel bearing, servicing
Special tools, testers and auxiliary items
required
n
Hub cap puller VW637/2
n
Seal installer 3241
n
Assembly tool 3420
n
Torque wrench V.A.G1332
n
Torque wrench V.A.G1410
Removing
- Lift vehicle.
- Remove wheel.
Wheel bearing, servicing
- Reset brake
- To do this use a screwdriver through the opening in the
brake drum and push adjuster upward.
- Remove phillips-head screw for brake drum and take out
brake drum.
Loosen dust cap from seat by tapping lightly on claw with
hub cap puller VW637/2 .
Wheel bearing, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст