Volkswagen Golf / Golf GTI / Jetta. Manual — part 539
3. Dust cap
¡
Pressing out and pressing in
for vehicles with disc brake
42-3, Wheel bearing/wheel
hub on vehicles with disc
brakes, removing and
installing
¡
Pressing out and pressing in
for vehicles with drum brake
42-3, Wheel bearing/wheel
hub on vehicles with drum
brakes, removing and
installing
¡
Always replace
4. Self-locking 12-point nut, 175 Nm
¡
Always replace
5. Wheel hub with wheel bearing
6. Axle beam
7. Brake caliper
¡
Servicing
A perfect seal is only achieved
using a new dust cap.
Only then is an optimum
function and long service life
guaranteed.
The wheel bearing and wheel
hub are installed together in a
housing.
This wheel bearing/hub unit is
maintenance and adjustment
free. Adjusting and servicing is
not possible!
Repair Manual, Brake System, Repair
Group 47, Servicing rear brake calipers
Wheel bearing, servicing
8. Stub axle
¡
Straightening operations are
not allowed
¡
Recutting thread is not
allowed!
Wheel bearing/wheel hub on vehicles with
disc brakes, removing and installing
Special tools, testers and auxiliary items
required
n
Hub cap puller VW637/2
n
Seal installer 3241
n
Installation sleeve wheel brg. 3420
Wheel bearing, servicing
n
Torque wrench V.A.G1332
n
Torque wrench V.A.G1410
Removing
- Lift vehicle.
- Remove wheel.
Loosen dust cap from seat by tapping lightly on claw with
hub cap puller VW637/2 .
- Pull off dust cap.
Wheel bearing, servicing
- Remove securing bolts - A - from brake caliper.
- Remove brake caliper and hang up on body.
- Remove phillips-head screw for brake disc and take out
brake disc.
- Remove 12-point nut.
- Pull off wheel bearing/wheel hub unit from stub axle.
A - Puller with leg clamp, e.g. Kukko 20/2
- Pull off bearing inner race from stub axle.
Only use puller - A - with leg clamp e.g. Kukko 204-2
(commercial type).
Wheel bearing, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст