Volkswagen Golf / Golf GTI / Jetta. Manual — part 225
24-154
Oxygen Sensor (O2S) Behind
Three Way Catalytic Converter
(TWC) -G130-, checking aging
Special tools and equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
Functions, checking
24-155
Test requirements
Functional check
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Exhaust system between Three
Way Catalytic Converter (TWC)
and cylinder head must be free
of leaks.
Coolant temperature must be at
least 85 C,
display group 1,
display zone 2.
Three Way Catalytic Converter
(TWC) temperature must be at
least 380 C,
display group
34, display zone 2.
- Connect VAG 1551 Scan tool (or
VAG 1552) and select engine
electronics control module with
"Address word" 01. Engine must
be running at idle speed: ((VAG
1551 and Motronic Engine
Control Module (ECM) -J220-,
connecting and selecting
Page
01-12
).
Functions, checking
24-156
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -4- for
function "Initiate basic setting"
and confirm entry with -Q- button.
Basic setting
Input display group number XXX
Indicated on display:
- Press buttons -0-, -4- and -3- for
"Display group number 43" and
confirm entry with -Q- button.
System in basic setting 43
1
2
3
4
Indicated on display: (1...4
display
zones)
When performing this test the Three
Way Catalytic Converter (TWC)
temperature in display zone 2 must
be at least 380 C.
Note:
This process can take approx. 30
seconds.
- Depress brake pedal and hold.
- Depress accelerator down to wide
open throttle position.
Engine speed will be increased by
Motronic Engine Control Module
(ECM) -J220- to approx. 2300
rpm.
- Depress brake pedal and
accelerator down and hold until
display in display zone 4 jumps
from "Test OFF" to "Test ON."
Functions, checking
24-157
- Depress and hold brake pedal and accelerator
until display zone 4 displays specification "B1-P2
OK."
- Release brake and accelerator pedals.
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
If the display does not indicate as described:
- Road test vehicle to remove possible residue on
Oxygen Sensor (O2S) and repeat check.
Observe the valid safety precautions when
performing a road test
Page 24-33
.
If the display does not indicate as described
again:
- Check Oxygen Sensor (O2S) and Oxygen
Sensor control after Three Way Catalytic
Converter (TWC)
Page 24-140
.
Functions, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст