Volkswagen Golf / Golf GTI / Jetta. Manual — part 223
24-146
Check basic voltage of Oxygen
Sensor (O2S) Behind Three Way
Catalytic Converter (TWC) -G130-
- Remove protective cover (arrows)
and disconnect 4-pin connector
(black) -1- to Oxygen Sensor
(O2S) Behind Three Way
Catalytic Converter (TWC) -G130-
.
If the specification is obtained:
- Connect multimeter to measure
voltage at terminals 3 and 4
(connector to ECM) using adapter
cables from VAG 1594.
- Start engine and measure basic
voltage.
Specification: 0.400 to 0.500 V
- Switch off ignition.
- Replace Oxygen Sensor (O2S)
Behind Three Way Catalytic
Converter (TWC) -G130-
Page
24-17
, item 18 .
Functions, checking
24-147
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
If the specification is not obtained:
- Check Oxygen Sensor (O2S) wiring of Oxygen
Sensor (O2S) Behind Three Way Catalytic
Converter (TWC) -G130-
Page 24-148
.
Functions, checking
24-148
Checking wiring for Oxygen
Sensor (O2S) Behind Three Way
Catalytic Converter (TWC) -G130-
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Remove protective cover (arrows)
and disconnect 4-pin connector
(black) -1- to Oxygen Sensor
(O2S) Behind Three Way
Catalytic Converter (TWC) -G130-
.
Functions, checking
24-149
If no wiring malfunction is detected:
- Check wiring for open circuit
between test box and 4-pin
connector (to control module)
referring to Electrical Wiring
Diagrams.
Terminal 3 and socket 68
Terminal 4 and socket 69
Wire resistance: max. 1.5
- Additionally check wires all for
short to one another.
Specification:
- Replace Motronic Engine Control
Module (ECM) -J220-
Page 24-
173
.
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Functions, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст