Volkswagen Golf / Golf GTI / Jetta. Manual — part 907
01-404
Erase DTC memory
Note:
The vehicle V.A.G 1552 System tester can be
used instead of the V.A.G 1551 scan tool,
however a print-out is not possible.
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-395
.
Prerequisites:
DTCs are repaired
Functional check has been carried out
DTC memory checked again
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -5- (the function "Erase
DTC memory" is entered with 05).
Rapid data transfer
Q
05 Erase DTC memory
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
DTC memory is erased!
Indicated on display:
- Press
button.
Driver's side seat adjustment, On Board Diagnostic (OBD)
13/2/2005
01-405
Rapid data transfer
HELP
Select function XX
Indicated on display:
Note:
WARNING!
DTC memory was not checked
If this appears in the display, the
test sequence is faulty.
Adhere strictly to test sequence;
first of all check DTC memory,
then erase memory.
- Press buttons -0- and -6- to end
the output.
Rapid data transfer
Q
06 End output
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
HELP
Enter address word XX
Indicated on display:
- Switch off ignition.
- Disconnect connector to V.A.G
1551 scan tool.
Driver's side seat adjustment, On Board Diagnostic (OBD)
13/2/2005
01-406
End Output
- Press buttons -0- and -6- to end
the output.
Rapid data transfer
Q
06 End output
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
HELP
Enter address word XX
Indicated on display:
- Switch off ignition.
- Disconnect connector to V.A.G
1551 scan tool.
Driver's side seat adjustment, On Board Diagnostic (OBD)
13/2/2005
01-407
DTC table
Note:
The DTC table is listed according to the 5 digit
code on the left.
Explanation of the malfunction types (e.g. "open
circuit/short circuit to Ground"):
Scan tool operating instructions
Before replacing components indicated as
malfunctioning, check the wiring and
connectors to these components as well as the
Ground connections using wiring diagram. This
is particularly relevant if malfunctions are output
as "occurring sporadically" (SP).
The malfunctions displayed can be localized
using the test table.
This malfunction "no communication" can also
appear with the door control modules. This has
no influence on the function of the convenience
system and is therefore of no consequence.
Erase DTC memory.
00668 049
Vehicle system voltage terminal 30
Signal too high
Scan tool print out: The number 049 (e.g.) shown
here in bold is not relevant.
Driver's side seat adjustment, On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст