Volkswagen Golf / Golf GTI / Jetta. Manual — part 227
24-162
Motronic Engine Control
Module (ECM) -J220-
Function
The Motronic Engine Control Module (ECM)
-J220- regulates the injection, Throttle Valve
Control Module -J338-, Oxygen Sensor
control, ignition, knock regulation,
Evaporative Emissions (EVAP) canister
purge regulator valve, speed limitation via
fuel injectors or Fuel Pump (FP) relay,
camshaft timing adjustment as well as On
Board Diagnostic (OBD).
Motronic Engine Control Module (ECM) -J220-
24-163
Engine Control Module (ECM)
voltage supply, checking
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Motronic Engine Control Module (ECM) -J220-
24-164
Test requirements
The fuses must be OK.
The main fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Motronic Engine Control Module (ECM) -J220-
24-165
Fuel Pump (FP) -J17- must be OK, checking:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
Motronic Engine Control Module (ECM)
Power Supply Relay -J271- must be OK.,
checking:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
Alternator OK., checking:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
Test sequence
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with"Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
Motronic Engine Control Module (ECM) -J220-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст