Volkswagen Golf / Golf GTI / Jetta. Manual — part 563
- Position special tool.
1 - Washer
- Pull out bonded rubber bushing by tightening spindle.
Installing
Installation position of bonded rubber bushing
Arrow on bonded rubber bushing - 1 - must point up or
down.
- Position special tool.
- Pull out bonded rubber bushing by turning spindle.
Subframe with final drive, assembly overview
1 - Bonded rubber bushing
Installation of subframe and spring is performed in reverse
order
Fastener/location
Tightening torques:
Mounting bracket to body
75 Nm
Stabilizer bar to subframe
20 Nm
Drive shaft to final drive
60 Nm
Mounting bracket to structure
75 Nm
Shock absorber to trailing arm
110 Nm
Cross member for final drive to subframe
60 Nm
Support for final drive to subframe
60 Nm
Subframe with final drive, assembly overview
42 - 7
Rear drive axle, servicing
Rear drive axle, removing and installing
Special tools, testers and auxiliary items required
n
Hub puller 3283
n
Angle wrench V.A.G1756
Removing
Left and right drive axle
- Lift vehicle until load on rear axle is relieved.
The wheel should still be touching the floor.
- Loosen 12-point nut.
Rear drive axle, servicing
- Disconnect drive axle - 1 - from final drive flange shaft - 2 -
.
Left drive axle
- Push exhaust system to side with a lever
- Remove drive axle inner joint from final drive.
1 - Exhaust system
2 - Drive shaft
The work sequence is valid for both sides
- Press out drive axle.
Rear drive axle, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст