Volkswagen Golf / Golf GTI / Jetta. Manual — part 790
Only Golf
- Remove molded headliner through rear lid out of vehicle.
Only Jetta
- Fold passenger seat backrest down and remove molded
headliner through rear door.
Only Golf wagon/Jetta wagon
- Remove molded headliner through rear lid out of vehicle.
Installing
- Installation is reverse of removal.
Headliner
13/2/2005
72 - 1
Front seats
Tools
Special tools, testers and auxiliary items required
n
Airbag adapter VAS 5094
n
Airbag adapter VAS 5232/1
Front seats, removing and installing
Caution!
Disconnect battery ground (GND) strap before working
on electrical system.
Note:
n
Removal and installation is described for left side of
vehicle. same instructions apply for removal and
installation for right-hand side.
n
Slight changes may have to be made to removal and
installation procedures, depending upon equipment
installed in vehicle.
Front seats
13/2/2005
n
Observe notes regarding coding in radio operators
manual before disconnecting battery.
n
After connecting battery, vehicle options (radio, clock,
electric window regulator) must be checked according
to repair manual and/or user manual.
Removing
- Switch ignition off.
- Disconnect vehicle battery
Repair Manual, Electrical Equipment, Repair Group 27,
disconnecting and connecting battery
Caution!
Observe safety precautions for working on airbags
69-4, Safety precautions when working on airbags
.
- Push seat forward.
- Unclip cover cap - 1 - from tunnel-side
cover strip - 3 - , unscrew bolt - 2 - , unclip
cover strip for seat rail - arrowA - and
remove - arrow B - .
- Unclip cover cap - 4 - from door sill-side
cover strip - 6 - , unscrew bolt - 5 - , unclip
cover strip for seat rail - arrowC - and
remove - arrow D - .
- Slide seat toward rear.
- Remove bolts - 7 - (23 Nm).
Front seats
13/2/2005
- Push seat back out of guide rail.
Caution!
Electrostatic charges may result in
involuntary deployment of airbag.
Therefore, mechanic must be
electrostatically discharged before
disconnecting ignition- and Ground
(GND) wires. This is done e.g. by
briefly grasping chassis or door
striker.
- Disconnect connector for side airbag - 1
- from connector station - 2 - .
- If installed, disconnect connector for seat
heater - 3 - from connector station.
Vehicles 07.00
- Connect connector - 4 - ( Airbag adapter
Front seats
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст