Volkswagen Golf / Golf GTI / Jetta. Manual — part 789
n
Golf wagon/Jetta wagon
70-6, Roof end strip,
removing and installing (Golf wagon/Jetta wagon)
.
- Loosen upper C-pillar trim:
n
Golf with side curtain protection
70-3, Upper C-
pillar trim, removing and installing (Golf with side
curtain protection)
.
n
Golf without side curtain protection
70-3, Upper C-
pillar trim, removing and installing (Golf without side
curtain protection)
.
n
Jetta with side curtain protection
70-3, Upper C-
pillar trim, removing and installing (Jetta with side
curtain protection )
.
n
Jetta without side curtain protection
70-3, Upper C-
pillar trim, removing and installing (Jetta without side
curtain protection)
.
n
Golf wagon/Jetta wagon with side curtain protection
04.01
70-3, Upper C-pillar trim, removing and
installing (Golf wagon/Jetta wagon with side curtain
protection 04.01)
.
n
Golf wagon/Jetta wagon with side curtain protection
05.01
70-3, Upper C-pillar trim, removing and
installing (Golf wagon/Jetta wagon with side curtain
protection 05.01 )
.
n
Golf wagon/Jetta wagon without side curtain
protection
70-3, Upper C-pillar trim, removing and
installing (Golf wagon/Jetta wagon without side
curtain protection)
.
- Remove upper D-pillar trim (Golf wagon/Jetta Wagon)
70-3, Upper D-pillar trim, removing and installing (Golf
wagon/Jetta wagon)
.
- Remove sun visor
68-2, Sun visor, removing and
installing
.
- Remove center sun visor
68-2, Center sun visor,
removing and installing
.
- Remove grab handle (roof)
68-2, Grab handle,
removing and installing (Roof)
- Remove door inner seals at top.
Headliner
13/2/2005
- Unclip trim - 1 - in direction of - arrow - and remove.
- Remove bolts - arrows - and unclip light unit from molded
headliner.
- Disconnect harness connector.
- Remove light for make-up mirror using a small
screwdriver.
- Disconnect harness connector.
Headliner
13/2/2005
- Remove interior light - 1 - and disconnect harness
connector.
Only Golf wagon/Jetta wagon
- Unclip caps - 1 - and - 6 - .
- Remove bolts - 2 - and - 7 - .
- Remove front lifting eyelet - 3 - and rear
Headliner
13/2/2005
lifting eyelet - 8 - .
All models
- Using Release tool 3344A - 1 - , press
spring - 2 - for reading light with interior
monitoring - 3 - toward rear.
- Remove reading light with interior
monitoring - 3 - and disconnect harness
connector.
Note:
n
When operating spring - 2 - , make
sure that Release tool 3344A - 1 -
does not stick between molded
headliner - 4 - and metal frame - 5 -
in molded headliner.
Headliner
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст