Volkswagen Golf / Golf GTI / Jetta. Manual — part 550
21. Hex bolt, 90 Nm
¡
Always replace
22. Bonded rubber mounting
¡
Removing and installing
42-
5, Trailing arm mountings,
removing and installing
23. Trailing arm
¡
Removing and installing
42-
5, Trailing arm, removing and
installing
¡
From 06.99 the thread -
arrowA - to mounting of buffer
stop
Item - 27 -
no longer
installed
¡
If the buffer stop
Item - 28 -
in trailing arm must be
installed before build date
06.99, the thread - arrow A -
must be extended to 10.5mm
diameter
24. Hex bolt, 75 Nm
¡
Always replace
25. Clevis mounting for rear axle
¡
Check and if necessary adjust
rear axle total track after
installation
¡
Alignment can be adjusted by
moving bearing bracket
26. Spacer
¡
Installed to vehicles with
heavy-duty suspension only
side of the vehicle!
A mixed installation is not
allowed
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
27. Buffer stop with threaded pin
¡
Tighten to 10 Nm
¡
No longer used after 06.99
¡
Buffer stop
Item - 28 -
supplied as a spare part
28. Buffer stop with locating pin
¡
Introduced from 06.99
¡
Correct installation position is
determined by locating pin
¡
Locating pin on underside
must be removed if buffer stop
is used on vehicles up to 06.99
¡
End of spring coil must lie
against the web - arrow - .
¡
Installation position of the
spring
42-4,
Rear wheel bearing, pressing out and in with
trailing arm installed
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
Special tools, testers and auxiliary items
required
n
Thrust piece 40 - 105
n
Hub puller 3283
n
Collar for wheel bearing inner race
3423
n
Engine/transmission jack V.A.G
1383 A with universal transmission
mount V.A.G1359/2
Special tools, testers and auxiliary items required
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
n
Foot pump with high pressure hose V.A.G1389A/1
If there is a hand pump V.A.G 1389/1 available in the
dealership it can be converted to a foot pump.
To do this use the conversion set V.A.G 1389/4 .
Special tools, testers and auxiliary items required
n
Hydraulic removing and installing tool for wheel
bearing V.A.G 1459 B
n
Piston cylinder HKZ-15 with hydraulic press piece E-
0-204-T
n
Removal rods E-0-217+218
n
Special nut E-8-214
n
Press piece E-5
n
Centering with clip E-76-2
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст