Volkswagen Golf / Golf GTI / Jetta. Manual — part 1086
27-85
9
-
Protective
cap
10
-
Generator
(GEN)
Tightening
torque of
B+ wire to
generator
Page
27-77
11 - Ribbed
belt
Removing
and
installing
Page
27-86
Ribbed
belt
routing
Page
27-91
12 - Hex
bolts
M8 x
85mm
25
Nm
13 - Hex
bolts
M8 x
45mm
25
Nm
Generator (GEN) - 4-cylinder gasoline engines
13/2/2005
27-86
Ribbed belt, removing and installing
CAUTION!
Before removing ribbed belt, mark direction
of rotation. Belt damage will result if not
reinstalled in proper direction.
Check ribbed belt
page 27-81
. Always
replace ribbed belt if found to be faulty. This
will avoid related failures or operating
problems.
Special tools and auxiliary items needed
Mandrel T10060 (or equivalent)
Generator (GEN) - 4-cylinder gasoline engines
13/2/2005
27-87
Removing
- Lift vehicle.
- Remove bolts -arrows- and
remove middle lower engine
cover (noise insulation).
- Remove nut, release clips -
arrows- and remove right lower
engine cover (noise insulation).
Generator (GEN) - 4-cylinder gasoline engines
13/2/2005
27-88
2.0L 4-cylinder gasoline engine:
Note:
European market 1.8L engine
illustrated here. Engine cover on
USA/CDN 2.0L engines is similar.
1.8L turbo 4-cylinder gasoline
engine:
- Release nuts -arrows- and lift
engine cover -A- from engine.
- Release screws -arrows- and lift
engine cover from engine.
Generator (GEN) - 4-cylinder gasoline engines
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст