Volkswagen Golf / Golf GTI / Jetta. Manual — part 364
01-138
Control module identification
The version of the control module is displayed
after the V.A.G 1551 scan tool or the tester VAS
5051 has been connected and the control
module for brake electronics has been selected
Page 01-163
.
1C0 907 379 C /
J
ABS
1C0 907 379 D /
K
ABS/EDL/ASR
1C0 907 379 E /
G
ABS/EDL/ASR/ESP
1C0 907 379 F /
H
ABS/EDL/ASR/ESP
4MOTION
Diagnostic Trouble Code (DTC) memory
A non-volatile memory ensures that the contents
of the DTC memory are retained even without
voltage.
Data output takes place on V.A.G 1551 scan tool
in operating mode 1 (rapid data transfer), and on
tester VAS 5051 in operating mode "vehicle
OBD".
ABS Mark 60 On Board Diagnostic (OBD), vehicles from my 10.00
01-139
Safety precautions and fundamental
points regarding troubleshooting
Note:
The ABS is a vehicle safety system; the
appropriate knowledge is necessary to work on
the system.
In order to check complaints and to be able to
carry out pin-pointed troubleshooting, the
Diagnostic Trouble Code (DTC) memory must
be checked before commencing work on the
ABS system.
Only separate connectors when the ignition is
switched off.
Observe the appropriate instructions regarding
the handling of brake fluid.
Repair Manual, Brake System, Repair Group
47
ABS malfunctions are indicated by the ABS
warning light illuminating. Certain malfunctions
will only be recognized at speeds above 20
km/h (approx. 13 mph) (carry out road test).
If the ABS -K47- and the brake system -K118-
warning lights do not illuminate, but the brake
system is not functioning correctly then the
malfunction must be sought in the conventional
braking system.
Repair Manual, Brake System, Repair Group
45
ABS Mark 60 On Board Diagnostic (OBD), vehicles from my 10.00
01-140
Technical information
Electrical Wiring Diagrams,
Troubleshooting &Component Locations
binder
Repair Manual, Brake System
Repair Manual, Suspension, Wheels,
Steering
ABS Mark 60 On Board Diagnostic (OBD), vehicles from my 10.00
01-141
Troubleshooting with V.A.G 1551 scan tool or tester VAS 5051 on ABS
Mark 60 (flow chart)
Start
Connect V.A.G 1551 Scan Tool and
select 1-rapid data transfer
or
Connect tester
VAS 5051 and
select vehicle
self-diagnosis
Compare control
module
identification
Select address word 03-Brake
electronics
Check DTC memory
02
Correct DTCs using DTC table
No DTCs
recognized
Read
measured
value block 08
Perform output Diagnostic
Test Mode (DTM) 03
Replace
comp.
1. Perform test drive at more than
20 km/h
2. Check DTC memory 02 again
3. "No DTCs recognized" is
displayed again
A B C
D
E
ABS Mark 60 On Board Diagnostic (OBD), vehicles from my 10.00
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст